0
1987 suburban stopped running now has no spark replaced coil cap rotor electronic ignition module in distributor?
Wiki User
∙ 16y ago
I'm not sure I understand your question. The ignition module is suspect in this case and yes, it's under the distributor cap. You may also want to replace the distributor cap and rotor while your at it, they're cheap parts and hair-line cracks in a distributor cap can be hard to detect. If all of these fail I'd look at replacing the coil and coil wire to the distributor.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
What produces spark on my 1997 suburban 5.7?
The ignition module that's in the distributor.
What would stop your injector from firing on a 92 Chevy Suburban?
Ignition module in the distributor.
How do you remove the ignition switch of a 97 Suburban?
you can take it to be replaced it has a recall on them
Where is the ignition distributor located on a 1998 suburban?
It is in the very back of the engine. Just follow the spark plug wires from the spark plugs and they will go to the top of the Distributor. That will be the distributor cap that the wires are in.
Would like info on ignition troubleshooting for 92 Chevy Suburban?
test ignition coil,ignition module,pick-up coil,electronic spark control,and knock sensor
What can be the problem of a 1994 Chevy Suburban 1500 will not start even though spark plugs coil and distributor replaced and there is no spark?
Is it a brand new distributor ? If not then replace the module and pick-up coil in the distributor that you have.
Where is the ignition module on a 1991 suburban?
It is inside the distributor, If you look at the right side of it you will see some electric wires and they are hooked to the module. Just remove the cap and then 2 screews that hold the module on the base of the distributor.
Does a 2002 suburban have a distributor cap?
No it does not.
No spark from ignition coil.Coil is new and still no spark for 1990 suburban?
I'd replace the ECM (electronic Control Module). These are often the problem on older GM vehicles. It's fairly simple to replace. It's located directly under the distributor cap and rotor. Costs about $60 for the part.
Where is the electronic spark control on a 1994 suburban 5.7 located at?
If I understand correctly, the Ignition Control Module is located inside of the distributor. To replace it remove the distributor cap, which is locted in the center rear of the engine compartment. If there is adequate room, leave the spark plug and coil wires attached. Set the cap aside and look for a wiring harnes on the bottom of the distributor. I should be attached to a small flat black module that has two small bolts holding it in place. Carefully remove the small bolts, and unplug the harness and remove the Ignition Control Module. Replace and assemble in reverse order. Make sure to get the distributor cap on the same way and do not rotate the distributor during the process.
Injectors not working on a 91 suburban?
If the injector wires are not broken where the air cleaner sets on top of the Throttle body, then I would replace the ignition module that's in the distributor underneith the dist. cap.
How do you adjust timing on a 99 Chevy 5.7 liter suburban?
That requires an OBDII engine scanner to do that. The ignition timing is controlled by the computor. If you have not moved are removed the distributor then there's no reason to fool with the timing.
