0
89 Chevy Corsica runs fine until it warms up then bogs like its lost power but will still work Just recently sometimes like 1 out of 10 wont crank right away Have to pump the gas to start.?
Wiki User
∙ 16y ago
You have the classic symptoms of a bad coil pack! Have been thru this about 6 times in the last 8 years. Check them. Could also not hurt to check fuel pressure/fuel filter
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Why did your 92 Chevy Corsica suddenly stall and never start again?
Could be your crank sensor. These are very common to fail on these cars.
Where is the crank sensor located on a 1988 4 cylinder Chevy Corsica?
It will be on the back side of the engine where the distributor used to be on older engines.
Does replacing the crank sensor in a 1991 Chevy Corsica stop it from stalling while driving?
IF... the crank sensor was the problem then it might. However, it is unlikely. I agree, although they are known to crack, It usually results in a no start condition from what I have seen.
What is the mpg Chevy blazer 1996?
It crank but it dos'nt start recently i pu some gas in the thraun then it start
Where is the location of the Crank Sensor on a 3.1 Corsica Engine?
The Chevrolet Corsica 3.1 liter engine crank sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crank sensor.
Where is the Location of the crank position sensor for 1994 Corsica 3.1?
its locted by the crank pulley the ower pully on the car
Where is the crank sensor located on your 1989 2.8liter Chevy Corsica?
behind the engine,in front of the transmission, about half way up the side of the block, its very hard to see its near the knock sensor.
Where is the crank shaft sensor for a 94 Chevy Corsica?
On 3.1L Engines it is on the front of the engine above the starter mounted in the engine block. On 2.2L engines it is above the oil filter mounted in the engine block.
Where is the crank sensor on a 2005 Chevy Impala?
where is the crank sensor located on a 2005 chevy impala
Where is the crank shaft sensor for a 1989 Chevy van 4.3 liter?
Chevy did not use a crank sensor on that year.
Where is crank sensor locted on 1993 Chevy lumuna car?
trying to locate crank shaft sencor for 1993 Chevy lumna trying to locate crank shaft sencor for 1993 Chevy lumna
Will a Chevy 350 crank fit in a Chevy 305 and what it make the engine with a stock bore ofcourse?
a Chevy 350 crank is a Chevy 305 crank. they have the same stroke, 3.48 inches, and are interchangable. swapping between the two cranks does not change the engines displacement
