0
97 Chrysler sebring What could cause the front left wheel to squeal but stop when you brake and only when in drive?
Wiki User
∙ 16y ago
Wear indicators on brake pads
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Brake problems on 97 Chrysler sebring?
Common brake problems on a 97 Chrysler Sebring can be caused by leaks, worn pads, and stuck calipers. Check your brake system as problems can cause a serious accident.
What would cause a 2004 chrysler sebring to die while going down the street after the emergency brake was pulled?
lots of strain on the engine i would imagine..
What will cause Front brake squeal 2001 FLHTPI?
Accumulation of brake dust, or brake pads that are nearing the end of their service life.
Why I keep blowing the starter fuse in my 2002 Chrysler Sebring?
A failed starter is a likely cause.
2001 Chrysler sebring sluggish on take off?
this could be the cause of a bad toque converter
Can a cam shaft sensor problem cause a 2002 Chrysler Sebring to stall and not restart?
Yes.
You just had brakes and rotors replaced and you get a high pitched squeal what could be causing it?
If the brake pads come with shims or other anti-rattle hardware and it is not used on the vehicle, the brake pads will vibrate against the rotor as they are being applied and that will cause them to squeal.
What causes a low idle in a 2002 Chrysler Sebring?
There are a few things that can cause a low idle in a 2002 Chrysler Sebring. The fuel pump may not be working right, the fuel injectors could be old, or the car could be low on oil.
Where do you spray lighter fluid to get a 1996 Chrysler Sebring to start?
You don't. That can cause a fire and internal engine damage.
Why does the blower fan only work on 3 or 4 in a Chrysler Sebring?
The usual cause is a failed blower motor resistor.
Why does the Fan motor for Chrysler Sebring not work in lows speeds only 4?
The common cause is a failed blower resistor.
What kind of damage can a broken timing belt on a 1996 Chrysler Sebring cause?
Valves can and will bend.Valves can and will bend.
