check the brakelight switch. it is located under the dash where the brake pedal rests. Hey its ritchie. If you can click your blinker down and then they work its you blinker switch,but this is my monte.
try replacing all sets of fuses for the hazard and the tail lights.
fuses are ok. replaced ignition multifunction switch and hazard, turn signal, cruise etc. switch. checked grounds. hazard lights when ignition is off but not in the on position. thanks Joe lapointe
Turn signal flasher?
If your 1999 Ford Expedition has turn signals that do not work but hazard lights that do work, it is likely that you have a fuse that is blown. You might also have a wiring issue including exposed wiring.
It needs checked out but both the hazard and brake lights go through the turn signal switch.
It could be a faulty ground wire.
Have you checked for the flasher unit for hazards not sure where to find it on a cherokee.
Lights or signals fits this 'fill in the blanks'-type question..
Is the hazard lights button not on top of the steering column ? The switch for the hazard lights on my 1995 Ford Explorer is part of the multi functin switch ( turn signals etc. )
If the turn signals on a car works but the hazard lights do not there may be a problem with the flasher switch. The flasher is located in the steering column, and a damaged unit can cause the lights to stop working.
Make sure hazard switch is pulled all the way out May be a problem in thw steering column
hazards and turn signals have separate flashers. replace flasher for turn signals