As long as you don't exceed the current rating of the cable.
If they are at the same voltage, and the same kW, the only thing left that will influence the output amperage is the power factor the generator is running at.
Power (P) = Voltage (V) x Amperage (I) Written as P=VxI or to find Voltage V=P/I Voltage is measured in Volts (V) Amperage is measured in Amperes (Amps or A) Power is measured in Watts (W)
The effect of diode voltage drop as the output voltage is that the input voltage will not be totally transferred to the output because power loss in the diode . The output voltage will then be given by: vout=(vin)-(the diode voltage drop).
power filter diagram
The input voltage range for the Toshiba power supply is AC 100V - 240V. The output voltage is DC 19V / output current is 4.74A. This power supply comes with a power cord and packaging will state voltage recommended for the product.
If they are at the same voltage, and the same kW, the only thing left that will influence the output amperage is the power factor the generator is running at.
If the 2 amps is the output amperage of the power supply, the maximum that should be drawn from the unit is 2 amps. The load amperage that is connected to the power supply should govern the amperage of the fuse used. There is not much range there, the fusing could go from .25 to 2 amps. If the input amperage is 2 amps then the input and output voltage of the power supply should be stated.
Depends on the voltage and amperage of the battery vs. the voltage and amperage required of the bicycle.
Power (P) = Voltage (V) x Amperage (I) Written as P=VxI or to find Voltage V=P/I Voltage is measured in Volts (V) Amperage is measured in Amperes (Amps or A) Power is measured in Watts (W)
Generally speaking an appliance (eg tv) is supplied with power so when it is off it has voltage supplied. After yo turn it on it starts to draw power called amperage the voltage doesn't get higheur but the amperage does Amperage is the load being drawn through a circiut
If a square wave is used instead of a sine wave in a transformer, the output power will operate at a different frequency. This will produces varying levels of voltage and amperage based on the wave.
The effect of diode voltage drop as the output voltage is that the input voltage will not be totally transferred to the output because power loss in the diode . The output voltage will then be given by: vout=(vin)-(the diode voltage drop).
Output power can never be more than input power. With a transformer, it is possible to increase the output current (while decreasing the output voltage), or to decrease the output current (while increasing the output voltage).
The two resistor voltage divider is used often to supply a voltage different from that of an available battery or power supply. In application the output voltage depends upon the resistance of the load it drives.
The values you state are two different values. KVA is the value of voltage times amperage times 1000. The voltage value of 240 volts is just 240 volts. If you have an amperage it can be applied to the first equation to find the KVA value.
The amperage of a motor is governed by the voltage that the motor operates on. Without a voltage given, an answer can not be given.
A: NO the power output will be higher. Bridge rectifiers do not provide more voltage output it just add more power by rectifying both positive and negative voltage of the AC input