0
Can Service drop conductor may be 14 awg hard-drawn copper based on 15 amp disconnecting means where installed to serve small loads of only one branch-circuit true or false?
Wiki User
∙ 9y ago
False. The minimum Service Drop Conductor size is a #6 Copper 75 Degree C and 90 Degree C Insulation or 60A. You would need a #4 or better in Aluminum with the same insulation values.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
How do you reset the ABS light after the alternator was installed?
disconnecting the battery for a few minutes usually does the trick.
Is a single pole switch considered a disconnecting means?
Yes, if the switch is sufficient for the circuit requirements and it is installed in sight of and within 50 feet of what it disconnects.
What is a cable terminal?
A cable terminal is a fixture designed to be installed in the end of a cable or conductor in order to facilitate the connection.
Why should a memory saver be installed before disconnecting a vehicle's battery?
A memory saver should be installed prior to disconnecting the battery from a vehicle so all of the personalized settings of the car owner will be saved. If this is not done, all radio stations as well as security codes for radio theft program and car alarm will have to be reset. many car owners do not have these codes and have to contact the dealership to gain access to them once they are cleared from the system.
What is the smallest size of a common grounding electrode conductor installed for multiple separately derived systems?
3/0 awg wire
Remote car starter stopped working after a new battery was installed How do you get it to work again?
If the remote car starter stopped working after a new battery was installed in the remote, the remote needs to be reprogrammed. If the remote starter stopped working after a new battery was installed in the vehicle, the computer might need to be reset by disconnecting the battery for a few minutes.
What is the largest size solid conductor generally permitted to be installed in a raceway?
the unit of admittance (Y) in A.C parallel circuit is
How do you change the radio in a 2002 Buick Century?
The radio in a 2002 Buick Century is changed by removing the bezel, disconnecting the wiring harness, and removing the retaining screws. It can then be pulled from its mounts and a new radio installed.
How do you replace the starter on 92 buick lesabre?
The starter on a 92 Buick LeSabre is replaced by disconnecting the battery, removing the retaining bolts, and lowering the starter. The wiring harness can then be disconnected and a new starter installed.
How do you replace Oil pressure sending unit?
The oil pressure sending unit is removed by disconnecting the wiring harness and unscrewing the unit using a wrench. The hole is then wiped clean, a new unit installed, and the wires reattached.
When installed in a cabinet in compliance with article 430 what is the smallest motor circuit conductor permitted it the motor has a full-load current of 4 amps?
14 Guage Cu
1996 ford f-150 4x4 351 ci your service engine light was on when you got the truck you checked for the code it said your 02 sensor was bad so you brought two of them installed them the lights stay on?
Try disconnecting the battery for 10 minutes to see if it will reset--if not have engine scanned Try disconnecting the battery for 10 minutes to see if it will reset--if not have engine scanned
