Yes, if the manufacturer installed a parallel blade 15 amp rating cap on the end of the cord then just plug it in. The circuit that you plug into should be a dedicated circuit (nothing else on the circuit) because the amperage will be 13 amps at 120 volts.
To my knowledge there is no such a thing as a 1000 volt cooking microwave oven. If you mean 1000 watt then the answer to your question is yes. W = A x V. Presuming that the 15 amp receptacle is on a 120 volt system then the amperage draw on a 1000 watt microwave oven would be A = W/V 1000/120 = 8.3 amps with 6.6 amps to spare.
As long as the voltages match a 60 amp service will handle a 700 watt microwave. The microwave will only draw A = W/V, A = 700/120 = 5.8 amps.
Considering an incandescent bulb and using P=VxI P= Power Watts V= Volts I= Current (amperes) I=P/V I=75Watts/120Volts = 0.625 Amperes (A or Amps) Therefore the current through a 75watt bulb that is connected to a 120volt circuit is 0.625 amps.
about 4800 watt but should not use it 100% so to be safe 4000 watt (80%)
The voltage needs to be known to give an answer to this question.
no a watt is a measurement of electricity
To my knowledge there is no such a thing as a 1000 volt cooking microwave oven. If you mean 1000 watt then the answer to your question is yes. W = A x V. Presuming that the 15 amp receptacle is on a 120 volt system then the amperage draw on a 1000 watt microwave oven would be A = W/V 1000/120 = 8.3 amps with 6.6 amps to spare.
It depends on the circuit that controls the siren. The circuit may be designed for only a 100 watt device and by doubling the current through the circuit, the circuit may be destroyed.
As long as the voltages match a 60 amp service will handle a 700 watt microwave. The microwave will only draw A = W/V, A = 700/120 = 5.8 amps.
To answer this question, you need to know how many amps the circuit that is connected to the light bulb can handle. For home applications with a 15 amp circuit and no other loads connected you get: Power = Current * voltage, Substituting the known information yields: power = 15 amps * 110 volts, which is 1650 watts of total capacity. You have 100 watt bulbs, so: 1650/100 = 16.5 bulbs If your circuit is other than 15 amps, or if there is additional loads on the circuit, you must adjust the current or total capacity accordingly
Current (amps)=Watts/Volts =2000/120 =16.75 =16.75 amps
2 minutes at the most 2 minutes and 30 seconds
Turn the microwave on for about 5 second, then look, then do it again untill it melts
A simple (and I do mean simple) formula is approximately 100 watts per amp. So, 700 watts total equals 7 amps, with 8 amps to spare on the 15 amp circuit breaker. It's really a bit more complicated than that, considering rms voltage/current equation, but it's close enough for government use. ;)
Power = voltage x currentCurrent = power/voltage = 12/120 = 0.1 ampere = 100 milliamperes
The current is half an amp because amps times volts equals watts.
The Daewoo KOR-6L0B is a low watt option.