No, the voltage of 500 volts is too high to operate a 380 volt motor.
Yes, a 200 volt squirrel cage motor can be run with about 100 volts.
no
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
It will not work at all.
ONE THING FOR SURE THERE IS NO CHANGE IN VOLTAGE IF SAME EQUIPMENT WE ARE TALKING ABOUT. THE ISSUE HERE IS THE CHANGING LOAD FREQUENCY 60HZ TO 50HZ OR VICE VERSA. FOR EXAMPLE THE MOTOR HORSEPOWER AND R.P.M. WILL BE APPROXIMATELY 90 AND 83 PERCENT OF THE NAMEPLATE SPECIFICATIONS, ALSO THE FULL LOAD RUNNING TORQUE WILL INCREASE APPROXIMATELY 8 PERCENT IF USED FROM 60HZ TO 50HZ.
no
One way would be to hook it up to a supply (by itself, with no load) and measure the speed with a contact tachometer. If your supply is 60Hz, and the motor speed corresponded to one of the standard motor speeds, it would be a pretty safe bet you had a 60Hz motor. If the speed was about 20% faster than a standard speed, the motor is probably a 50Hz motor. Or 20% slower if you were running a 60Hz motor on 50Hz For instance, a 1750 RPM 50Hz motor would spin at about 2100 RPM if you ran it on 60Hz.
What effect will be there on the motor (Induction) output power when a 100kW 50hz motor is connected to a 60hz power supply.
Depends on the current rating which should be on the motor.
You need a 5.5kw generator to run a 5.5kw motor.
100
230V/1Ph/50Hz 1HP (0.75 kW)Motor Capacitor start induction motor ( single phase)
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?
It will not work at all.
Yes, But in this case the current will rise up by about 15% at full load. So if you will use the motor to drive any mechanical load take in your consideration the mechanical load Power (KW) must not exceed 85% of motor power (KW)
I HAVE A 15KW 50Hz 400V VEM MOTOR , I WANT TO RENEWAL THE GREASE
Yes. It will make your motor a little faster though, so it depends on what you are powering with this motor. IE Can the piece of eguipment be ran faster?