0
Yes it can run because motors have 10% voltage variation tolerance so it can operate between 380v - 440v band.
Sonny Borer
Wiki User
∙ 16y agoyes you can run this 415 volt electric motor to a 380 volts supply, however higher curren will develop as you go full load. reduce the full load by 30%
Wiki User
∙ 12y agoProviding the Motor has a CE marking on the data plate. This means it has been tested and compliance with European standards.
Wiki User
∙ 14y agoYes, for several minutes until the motor burns up! Don't put 440V to a 380V motor.
Wiki User
∙ 14y ago30hp how many kw
Kamal Ahmed
Same question ?
Add your answer:
Earn +20 pts
How can you run a 380VAC 3-phase 50hz motor on a 220VAC 3-phase 60hz supply?
Is there anyway to get 220V 60hz from a 110V 50hz power supply?
It would involve some electronics work but it could be done. Might add that it could be more expensive than just buying the proper power supply. Use Use 220V 60hz motor to run 110V 50hz Generator.
What is the cable size for a 26kw induction motor 50metre run for cable 415v?
Wire sizing is determined by the amount of amperage that the connected device draws. Look on the nameplate of the motor and state the amperage. Then the question can be answered.
What size inverter in watts is needed to run a 1.5 horsepower motor?
To answer this question, the voltage whether the supply is single or three phase, of the 1.5 HP motor must be given.
What is the simplest way to run a 3 phase 380 V motor of about 1 KW directly on 220 V single phase supply without resorting to rewinding or frequency converters?
You cannot run a three phase motor on single phase power. You'll burn the motor up within minutes. By the way, I've never seen or heard of a 380 volt motor. Do you mean a 480 volt motor? If so, the only way you can power it is with the correct full voltage and a 3 phase power supply.
Can a 415v 50hz motor run on 380v 50hz?
no
Can a 415V 3-phase 50 Hz motor run on 380V 3 phase 60 Hz?
Yes, it will run drawing little more extra current in similar conditions. The motor is expected to be running in lesser rpm as well.
How can you run a 220v 3-phase 60hz motor on a 380v 3-phase supply?
Not advisable, the voltage differential is too great.
Can a 440 - 480V 60Hz motor run in a site with 380V 60Hz supply If No how can it work?
The motor will run, probably at nearly the same speed, but it cannot supply the same mechanical load. If it can be run on a lighter load, proportional to the voltage, it should be OK.
If a 6.6KV Motor run at 415V then what happen to its current and RPM?
Current shall increase while you apply 415V for operating it and will decrease the rpm to a much low level.
Can a 415V motor run on 525V?
It is not advisable to do so. You may burn the winding, insulation may fail.
How do you make a 380v motor run on 220v?
Yes just connect any line to neutral you have 230volts already.
380v motor on 415v?
Answer for European SystemsThe nominal line-to-line voltage used for single-phase supplies in Europe is 400 V. In the UK, this voltage is allowed to vary between -6% and +10%; in other words, it can vary between 376 V and 440 V. So it would be quite acceptable for a 380-V and a 415-V motor to operate on this system.
Can you run a 460v 60hz motor to a 480v supply?
The the supply stays within +/- 5% of what the motor is rated for, you can do this.
Can you run a 415v 3 phase motor on 480 3phase?
It would not be immediately dangerous but there is a possibility of overheating with the 9% overvoltage so it isn't a good idea unless the motor is lightly loaded and watched very carefully. The safe voltage range should be marked on the motor.
How do you do solo test for motor?
just connect the supply of motor to power supply..and run..then ovserve the motor sounds,temperature and vibration.
How do run 380V motor in 440V supply voltage?
You can use a voltage regulator IC/transistor that can take any input voltage (to a point) and spit out whatever voltage you want, depending on your application (in this case 380 volts) then be sure you build a regulator with the correct IC/transistor. Hope this helps!
