You need a step down transformer. A transformer that will step 240 volts to 120 volts. Check with Radio shack or your local electrical supplier. This saw draws 15 amps when it is running (1800 watts). It will draw close to 30 amp instantaneous when it starts. The transformer that you will need, should have at least a 2KVA rating. Even better a 2.5KVA.
No. The neon sign is fed by a step-up transformer. Primary side 120V, secondary side 7500V. If you applied 240 to the primary side you would get 15000 volts on the neon tube. A flash over and then nothing. If you can find a transformer from 120V to 240V or 240V to 120V then you are good to go. Connect 240V to 240V side and you will get 120V out the other, connect the 120V side to the neon sign and you should have light. Transformer should be at least 100va. This will give you an output of .83 amps at 120V
Electronic technician will convert in no time. You need 240v power transformer in place of same wattage 120V. Super easy.
It depends on the voltage source. watts = voltage * voltage / resistance and amps = voltage / resistance example 1: To produce 600W from a 120V source, you need a resistor of size 120V*120V/600W = 24 Ohm. This would pull 120V/24 Ohm = 5 amps. example 2: To produce 600W from a 240V source, you need a resistor of size 240V*240V/600W = 96 Ohm. This would pull 240V/96 Ohm = 2.5 amps.
120v /240v
Absoluteyl not.
No.
No. The neon sign is fed by a step-up transformer. Primary side 120V, secondary side 7500V. If you applied 240 to the primary side you would get 15000 volts on the neon tube. A flash over and then nothing. If you can find a transformer from 120V to 240V or 240V to 120V then you are good to go. Connect 240V to 240V side and you will get 120V out the other, connect the 120V side to the neon sign and you should have light. Transformer should be at least 100va. This will give you an output of .83 amps at 120V
It will work it you use 240 volt light bulbs.
In the US, both 120v and 240v will be needed for your home, as different appliances need different voltages. Your TV needs 120V, while your electric dryer and stove will need a 120V/240V supply. If you have an electric water heater, or central AC unit, they will need a 240V supply.
Because they are "in-phase". In order to get 240v, you need two 120v Alternating Current lines that are 180° out of phase, that is, opposite phases. Only when one line is +120v and the other -120v will you see 240v between the wires.
Electronic technician will convert in no time. You need 240v power transformer in place of same wattage 120V. Super easy.
Off hand no but your explanations are not clear as to who is doing what to whom,,
You can use 120v 10a 125w cable projectors 110-240v power in India.
Power adaptors are readily available that plug into Australia's 240v outlets, converting to 120v. Find them in travel, luggage and electronics stores.
120v and 240v
Dewalt by far.Have used a stand up for 8 years with no problems.
You will burn up your appliance!!!!!