not smart to do it cant carry the load of the circuit it will blow. in emergency maybe but never go with a higher rating
Yes, but it may blow if the load draws more than 10 amps.
You risk too much current flow in the circuit. Overloading the wiring can cause a fire.
No, you could overload the wiring and start a fire.
no you cannot, it is dangerous, you need to have a 20 amp service installed in order to do that. hope i helped
( # 4 ) is a 10 amp fuse for the left headlamp , ( # 8 ) is a 10 amp fuse for the right headlamp and ( # 33 ) is a 15 amp fuse for the high beam headlamps
fuse number 1 is 10 amp fuse 2 is 25 amp fuse 3is 25 amp fuse 4 is a spare fuse 5 is 10 amp fuse 6 is a spare fuse 7 is 20 amp fuse 8 is 25 amp fuse 9 is 20 amp fuse 10 is 5 amp fuse 11 is 5 amp fuse 12 is a spare fuse 13 is 5 amp fuse 14 is 15 amp
No, as soon as you turn on the appliance the wire inside the fuse will melt as there will be too muck current flowing through it
replace the 15 amp fuse replace the 15 amp fuse
Its a 15 amp fuse in the fuse box under the hood on the passenger side near the front. Its the only 15 amp fuse and it is in a clip. Remove the clip, replace the fuse and then reset the clip.
Not a good idea. The 15 amp fuse will be protection a #14 wire which is rated for 15 amps maximum capacity. By changing the 15 amp fuse to a 30 amp fuse you would then be allowing 30 amps maximum capacity on a #14 wire. By doubling the load the extra heat generated on the smaller wire could be enough to melt the insulation from the wire and that could cause the wire to short out. If the wire shorts out inside the wall it means the removal of the wall board to replace the wire to restore the circuit to an operational condition. The proper wire sizing for a 30 amp fuse is, #10 copper wire with an insulation rating of 90 degrees C.
There is one 15 amp fuse, one 10 amp and one 5 amp fuse.
Check the back of the fuse panel to make sure your putting the proper fuse in. But do NOT put a fuse to big in. So if your fuse panel calls for a 15 amp fuse, replace with 15 amp fuse.