Certainly look up Flagg Flow T.P Fittings
T.P thread-less copper fittings will FIT on schedule 40/80 /120 Brass pipe Ideally it should be brazed but soldering will hold domestic water pressures
Also many solder fittings ARE CAST BRASS rather then wrought copper
As long as it is a sweat fitting. The term for soldering copper is to sweat it. Don't ask me why.
Take either an SOS pad or a wire brush and rough up both the inside of the brass fitting and outside of copper pipe, put the copper pipe into the fitting and solder around it.
Yes
Solder can be used on any grade of brass or copper.
*Yes you can solder brass, as long as it isn't the decorative polished brass. They have used brass fittings in plumbing for years and years. It has the same characteristics as copper.
Sure why not
Solder, (lead + tin); Brass, (copper + zinc); Bronze, (copper + tin).
1st you need to know where the leak is. The only time a copper fitting or brass fitting will fix a leak is in the watersupply connection.
It is probably referring to the type of fitting. A fitting that is soldered to a copper pipe. It is called sweating when you use solder and a torch to connect copper pipe together or attach fittings to copper pipe.
You cannot solder Steel BUT you can braze steel and copper and you can thread steel and then use a copper x female adapter Or finf a steel fitting and use a C x M adapter
Yes, you can either solder them or fit mechanical (threaded) fittings.
In order to connect a chromed steel pipe to a copper pipe, you will need a brass fitting. These two pipes will not fit into each other otherwise.
Tin, copper, lead. (So Bronze, solder, brass.)