AS long as the impedance is a match you can use any speake with any amp. But if the power ratings are too mismatched don't expect it to sound that good. If the amp is stronger than the speaker, the speaker can be damaged if you crank the amp up high. And if you hook an amp to a too strong speaker the amp might have trouble powering it properly.
Yes you can. The amplifier will not drive the speaker to its full power and it is important that you don't allow the amplifier to be driven hard enough to distort. Other than that, there shouldn't be any problem at all.
You CAN, but if you turn the volume too high you will destroy the speaker unless there is a fuse between them. Try a 2 or 3 amp fuse at these power levels.
There is nothing stopping you, but you risk blowing out the speaker
Yes, provided you are careful not to accidentally run it at more than 3/4 power.
They can be as loud, as the amp is not delivering 600 watts. The 10" sub rated at 600 watts is able to withstand more power.
It will have the potential to over drive the speaker elements and can cause distortion and potential speaker damage.
Speakers can be blown if the wrong power amplifier is used and damage can be done by either overpowering or underpowering the amp. For example, if the power rating of the speaker is 300 watts capacity you will need a 300- to 600-watt amp.
yes
No, that's just the maximum capacity of the speakers. You can always run them at less than their maximum rating.
yes it can
Absolutely!! If you turn up the gain too much, the speakers will smoke. You can use it at a lower level
I am not a sound man but an electrician. But as I understand it, speakers only receive power. So if you connect 300 watt speakers to a 250 watt amp, you can only get 250 watts out of the speakers. If this understanding is correct, this could not blow your amp. I might say, however, that in most things electrical, they are not intended to be used at maximum output for very long. So if this understanding stays true with sound equipment, then running your 250 watt amp at maximum output in an attempt to get 300 watts out of it, this could shorten the life of your amp even though you never actually overload it.
It's actually a good idea to have a speaker that can handle higher wattage than the amp can produce.
sure you can, your amp will only deliver 52 watts to the speaker, more importend would be the impedance of the speaker . it should be equal to what your amp has! may be 8 ohms
It depends on the rms of the two cvrs combined. Also if the 1200 watt amp is 1200 watt rated (rms) or 1200 watt peak. Lets say the two kickers have an rms of 600 watt each, and the amp is 1200 watt rms, which it probably isnt but i'll pretend. This set up would work because 600 of the amps watts would be correctly matched with one sub, and the other 600 would go to the other sub.
nope your powering it just right