If you have access to a coil tester, spark plug should fire steadily at the 1.5 setting on the current knob. To test continuity of the coil: Primary test; connect a test lead to one side of the coil and the other lead to the other side of the coil. Readings shold be between 3.5 to 5.5 ohms. If readings are high or low, replace the coil. Secondary test; remove plug wires from plug and place test leads on plug wires. Readings should be between 68 minimum and 78 ohms maximum. If readings are high or low replace coil. There should never be continuity between the primary and secondary windings. This information is taken from the JD 400 service manual. On a side note, my secondary reading from my tractor is only 40 ohms. Primary was 4.1. The tractor runs great.
Lt133 lawn tractor will not fire is coil bad
If you mean the ignition coil, then I believe its located under the engine flywheel.
More than likely it is a bad ignition coil.
You test an ignition coil by checking the resistance with an ohm meter. The resistance values should be something like, Primary winding .3 to 1 ohms, Secondary winding 8,000 to 11,500 ohms.
The ignition coil is inside the ignition distributor.
Try checking the ignition coil #2. Also check the spark plug and its wire.
No. The coil provides the spark and the module tells the coil when to spark.
The 1998 Toyota ignition coil is located on the firewall, in the engine compartment. The ignition coil can be found on the passenger side of the firewall.
REMOVAL PROCEDURE Remove the engine cover. Disconnect the spark plug wires at the ignition coils. Disconnect the ignition coil harness connector. Remove the ignition coil mounting bolts. Remove the ignition coil. INSTALLATION PROCEDURE Install the ignition coil to the bracket. Install the ignition coil mounting bolts. NOTE: Refer to Fastener Notice in Service Precautions. Tighten Tighten the ignition coil mounting bolts to 8 N.m (71 lb in) . Connect the ignition coil harness connector. Connect the spark plug wires at the ignition coils. Install the engine cover.
Where all the wires plug into. That is the ignition coil. The ignition coil is inside the distributor behind the cap. Remove the distributor cap screws, remove the cap and you will see the coil.
1999 Alero how do i test ignition coil pack
The ignition coil that is suitable for the hall sensor ignition must have a yellow label.