What would you like to do?
Answer The 383 Stroker firing order is 1-8-4-3-6-5-7-2
All of the late Chevy small blocks have a firing order of 1-8-4-3-6-5-7-2. The rotor in the distributor as you look down upon it turns clockwise.
All small block chevy's standard firing order is 18436572.
Yes the engine turns clockwise. Start at #1 on the cap and wire it clockwise. 1-8-4-3-6-5-7-2
1-8-4-3-6-5-7-2 clockwise on distributor cap. Driver's side head front to rear is 1-3-5-7 The other head .........................is 2-4-6-8
the 327 Chevy was buiit with anywhere from 210 hp with a 2 bbl carb to 375hp with fuel injection and everywhere in between.
1-8-4-3-6-5-7-2 clockwise on the distributor cap. Cylinders #s are in this order. Drivers side head front to rear is #s 1-3-5-7 The other head front to rear is 2-4-6-8
On the intake manifold, just left of the distributor, from the front, you will see two raised, threaded holes. There is a bracket that goes around the coil, and bolts to those… two hole, with two, 1/2 inch long, 5/16ths, NC, bolts, with a star washer, on each. That is all stock. If you are rodding this vehicle, I can advise you of a trick, I picked up. Get a radiator hose clamp, and drill a hole through it, and then the firewall, near the distributor. Bolt the clamp to the firewall. Then, tighten the clamp around the coil, holding it up, and out of the way, and cooler, than on the intake.