What would you like to do?
Does the close door button on a Otis elevator work?
You have to push the button to simulate a closed door before your electronic lock will work any ideas about what is wrong?
Answer Nothing is wrong. This is a safety feature used on modern vehicles. All doors must be closed before atuomatic locks initiate. It's intended to protect you… from locking your keys in the car, or your children accidently locking you out.
NEW YORK, IN A BEDSTEAD FACTORY
When you press the button, a microswitch creates a circuit. That circuit sends a signal to the elevator controller, which is a computer that runs the elevator. Instantly, the …controller powers the light inside the button, which is usually an LED. At the same time, the elevator is dispatched to your location based on a mathematical formula. Once the elevator arrives, the LEDs in the button are turned off. Buttons vary greatly, but a generally divided into vandal resistant or plastic. Vandal resistance is typically defined as a metal button that lands on solid metal when depressed. See www.epco.us for examples of many kinds of buttons.
Yonkers, New York Incorrect question being asked, Elisha did not invent the elevator, he invented the safety break system. As welll as invented an automatic bread baking oven.…
63 million 584 thousand
It's not used much, but it's not completely useless: * If you need to get to another floor quite quickly, using the close door button will start the elevator a fe…w seconds earlier. * If you pressed the open door button without needing to, using the close door button may cancel the wait
The Otis elevator brake was built to suspend the car safely in the shaft if an elevator cable snapped. Otis started experimenting on how to make the brake by placing a wagon s…pring above the hoist platform. Then, he attached a ratchet bar to the guide rails on the sides of the hoistway. The lifting rope was next fastened to the wagon spring so that the weight of the hoist platform held just enough tension on the spring to keep it from touching the ratchet bars. However, if the cable snapped, the tension would be released from the spring. It would then immediately engage the ratchets, preventing the platform from falling.
it depends on where it is
No. Otis has purchased many companies over it's long history, but Thyssen Krupp Elevators is not one of them.
If the remote locks the door properly that tells me that the wiring and the lock solenoids are operating OK. I'm also taking it for granted that the switch you spoke of is the… door lock switch on the drivers door. Does the passenger door switch work properly? If so, then you probably have a bad switch on the drivers door. (IMPROVE) You can remove the door lock mechanism from the panel and gently pry open. Carbon build-up is common on the switches. Use a pencil eraser to remove the carbon and ensure the switch functions properly. Re-assemble.
Why does the garage door close when the button is pushed but does not open or close with the remote?
the batteries are either dead or the remote is crap Batteries dead, remote broken, OR- most remotes have a security code that must match the code set on the door closer. Ch…eck to see if they have been changed- usually a row of tiny 2 position switches.
Otis Elevator Company does not have a ticker symbol. It is a wholly-owned subsidiary of United Technologies, whose ticker symbol is UTC.
Absolutely. If you leave the doors open, the air conditioner will need to work over capacity as you are allowing warm air into the area. As well as warm air entering, you are …allowing the cooled air to exit. Having the doors open means that the air will not cool to the temperature you have set the air conditioner to, and it will be using far more electricity than it usually would with the doors closed.
most of the time
The population of Otis Elevator Company is 61,000.