Looking at engine Passenger Side (Front to Back) 1-4, Driver's Side (Front to Back) 5-8

Ford E-series vans have a pigtail in the wire harness tucked beneath the drip rail

in the engine compartment. There's a marked speed wire there - grey/black, 8000ppm.

A running or going out or forth; an expedition; a sally., A journey chiefly for recreation; a pleasure trip; a brief tour; as, an excursion into the country., A wandering from a subject; digression., Length of stroke, as of a piston; stroke. [An awkward use of the word.]

about 700 pounds

dirty lenses or wiring issue (corrosion),

NOTHING

Borrow, rent or buy a good quality OBD2 code scanner. The good ones let you clear the codes. Any codes that WON'T clear are usually caused by a failed component that needs to be replaced.

I'm not sure, however I use mine to hold the trash sack!

because the shoxs go as far as they can go up and it hits the frame. But will not cause any damage.

try turning the key over

It could just be that the arm for the lock inside the door has come off, you will need a new retaining clip before you take the door panel off to repair it.

hes a speical costume for christie montearo 1st get 500.00 or 500.000 then go to costimize mode then choose christie then buy that speical costume wen trying eddy out find christie then press triangel then eddy will be there

8,900 pounds....empty diesel fuel tank

A throwback park legend who is rated 52 overall basketball player who is attending reavis and is going to duke next year.

The first and cheepest thing to check is the fuses. located on the side of the dash by the passengers door, another is under the hood on top of the battery. The next would be lock switch.It is easily installed, no tools needed. The drivers side power switch is a master switch. This means that power feeds from the drivers lock switch to the passenger door. If your key fob will unlock and lock the doors but the switch will not I would replace the drivers door lock switch.

Your vehicle has a factory set 5 digit code that operates the keyless entry system. The factory-set code is located on the owner's wallet card in the glove compartment. If you are like me and bought the vehicle without the card in the glove box, you will find websites that will tell you to take it to the dealer and have them read the ECM. This was not necessary in my case, I have a 2002 Ford Excursion 4X4 7.3L Diesel. The ECM was located behind the radio up under the dash.( The ECM is the brainbox and is about 7"x 7" x 1" thick) . First, Move the drivers seat as far back as possible. Second, Lay on the floor with a good flashlight and mirror. I was able to see it in the mirror. Now you have to be able to read things backwards in a mirror. You may have to write the numbers down and try it backwards. This is the factory preset code. (5 digits). When you shut the drivers door and try this make SURE you have removed the keys from inside the vehicle! AGAIN, MAKE SURE YOU HAVE REMOVED THE KEYS FROM THE VEHICLE! Don't ask me why I am reitterating this! Next, enter the code and then push the 1/2 key. If this is the correct code you should see the door locks move. Whithin 5 seconds enter your code (5 digits) and you should see the locks move again. BINGO! I AM SO GLAD THAT WORKED!

I am currently wondering the same thing.

This is the best answer I have found so far, so it doesn't look like it...

excursion lug pattern is 8on170mm

older f250 lug pattern is 8on6.5in

170mm=6.69inches, close but not equal

have you checked to batteries in the remote?

Your vehicle has a factory set 5 digit code that operates the keyless entry system. You can also program your own 5 digit personal entry code. The factory-set code is located on the owner's wallet card in the glove compartment.

check out www . motorcraft service . com ( no spaces ) click on Owner Guides a diagram / list for the fuse panel can be viewed on-line

A whirlpool.

An eddy is water that flows opposite from the normal flow of a river. When a river's water level rises, tributaries that point in the opposite direstion of the flow of the river will rise too. This water will flow upstream in the tributaries and fill them to the level of the river. In some regional areas, such as southern states of the US, an eddy is a part of a river that is set off from the river where the water has no flow at all unless the river is rising.