answersLogoWhite

0

Oldsmobile Cutlass 442

The Oldsmobile Cutlass 442 was a high-performance muscle car manufactured by General Motors from 1964 to 1980. Four generations of this car were produced – all were equipped with front engine and rear-wheel drive.

500 Questions

What is the Oldsmobile 442 stock engine?

User Avatar

Asked by Wiki User

Depends on what year 4-4-2 you're referring to...

Where is the exterior paint code for 1993 Buick Century?

User Avatar

Asked by Eagle275

There is a sticker on the inside of the trunk lid that has that information.

What is the gas mileage for a 1985 Oldsmobile cutlass?

User Avatar

Asked by Wiki User

Between 15 and 19 MPG.


I had an '86 with 307 4bbl....still computer controlled. Running a TH350 and 2:29 gears it averaged 26 MPG at 70-75 from Flagstaff, AZ to St. Louis, MO. Depends on state of engine, gears, tranny, how you drive it, etc.

Can a 71 olds cutlass that was made in the 442 plant and has a 336 vin with w30 0ptions be real or is it a clone?

User Avatar

Asked by Wiki User

That depends. '71 W30's were made at Lansing MI, so the VIN must have the M.

The VIN must be 344... or it's not a factory 442... HOWEVER, and beware here,

the BODY TAG, which is NOT the VIN... can be for a Cutlass body [336...] at least for the '68-9 Lansing built cars.

*THE* VIN is the dashboard sequence like

344671M001442

and all '68 thru '71 442's [and ONLY 442's] sport the "44" model series identifying digits.

Sign up for free at wildaboutcars.com and learn all about almost any year's VIN and models.

What is the bolt pattern of a 1997 Oldsmobile Cutlass?

User Avatar

Asked by Wiki User

OLDSMOBILECUTLASS SUPREME (FWD)1988-97Metric: 5 X 115

Standard: 5 X 4.5216 X 6 12 X 1.5 70.3

How do you put a wheel cylinder on?

User Avatar

Asked by Wiki User

take the brake line out of it and there are 2 bolts on the back of the wheel cylinder that come out and it's off.

Where do the vacuum lines go to from the tcs switch?

User Avatar

Asked by Wiki User

If I understand your question right, you should have 4 vacuum lines connected to it. The top one connects to the carb by the bowl area; the next one connects to the rear of the carb; the next one comes from the vacuum advance on the distributor and connects to the middle vacuum port on the TCS; the last one connects to the trans line and to the front of the intake manifold. You use a "T" in the line for this one. If you had a GM factory repair manual you'll find a drawing showing how the lines go. Check, YearOne, OPGI, the Parts Place, USA parts, Kanter auto parts, etc.