0
Mitsubishi Endeavor
The Mitsubishi Endeavor is a mid-size crossover sport utility vehicle produced from 2004 to the present. Based on the Mitsubishi PS platform, the car features a 3.8 L SOHC 24v V6 engine and a 4-speed semi-automatic transmission.
500 Questions
Latch lock on 2004 Endeavor won't open from outside only inside release?
Asked by Wiki User
I had a similar problem. My latch on my 20004 endeavor would not stay shut and as I drove along, it would keep popping open. Turned out the sensors just needed to be adjusted. Take it to the dealer, takes five minutes.
How do you replace a timing belt on a Mitsubishi Endeavor?
Asked by Wiki User
How do you replace a timing belt on a Mitsubishi Endeavor 2004? (en francais si possible)
Read more: http://wiki.answers.com/How_do_you_replace_a_timing_belt_on_a_Mitsubishi_Endeavor#ixzz1p65Hf8AS
What does the exclamation point signal on the dashboard flashing mean on a 2004 Endeavor?
Asked by Wiki User
Tire pressure warning light either low tire pressure or uneven tire pressure
When should you replace the timing belt on your Mitsubishi outlander 2003 with 65000 miles?
Asked by Wiki User
65,000??? Now would be good but you can go a little longer. I have seen many with 80,000. After that you are pushing the limit. Don't forget to replace the water pump at the same time (and the tensioner pulley too but not mandatory)
How do you remove the passenger front door panel on a Mitsubishi endeavor?
Asked by Wiki User
1. Turn off the Battery power by disconnecting the negative pole of the battery
2. Be sure the glass of the door is on the up position to prevent breakage
3. Remove the 2 screws on the handle of the door panel
4. Remove 1 screw behind the handle on the lock latch
5. Remove the plastic cover on the latch using a screw driver wrapped with a rag to prevent damage to the plastic. Start working anteriorly (front of vehicle) to posterior. Try to insert a small screw driver to release the "clip lock" of the cover which is found near the hinge of the latch. Be very careful not to break this plastic cover. For me this is the hardest part to do.
6. Pry out the cover of the door light with a screw driver wrapped with a rag. Remove the bulb and remove the small screw and detach the light housing from the connector.
7. Pry upward the whole housing unit where the controls of the mirror, door lock etc. from the door panel handle (this is secured only by clips). You can use your fingers to do this but you can use the protected screw driver as well. Disconnect the connectors
8. Now, you are ready to detach the whole door panel. The plastic door panel is attached to the door by several clips. Look under the door and you will see two small rectangular notches on the panel. Try to insert a protected screw driver thru it and try to pry out and dis-engage the clips that hold the door panel. There are several of these. Try to sweep the screw driver in to locate the other clips.
Where is the ac drain hose for 2004 endeavor?
Asked by Wiki User
I saw on another site that it is located under the dash hidden in the heating unit. If you are having problems with the driver's side floor board getting soaked after driving look around on-line. There are MANY complaints and suggestions out there. Right now I am doing what I can to have Mitsubishi pay for my line to be cleaned and the insulation to be replaced as many people have paid anywhere from $300-900 to have this fixed. I DON'T THINK SO. Hope this helps.
