The inductance primarily serves to limit current flow to the correct level for the tube. It also can be used during startup to provide an inductive 'kick' forming a higher-voltage pulse to start the lamp.
The choke is used to give a surge of current during start up. This choke coupled with a relay (or sort of switch) will start to magnetize to its max capacity, once attained maximum level, relay trips and the choke start to discharge thus providing initial surge of current need to light on the fluorescent tube.
The 'choke' is an inductor whose purpose is to limit the current flowing through the tube after the gas has ionised.
choke is connected in series not parallel.lol
glass
A pin based fluorescent light fixture is the type of fixture that takes fluorescent tubes. On each end of the fluorescent tubes there are contact pins. These pins are used to hold the tube in the fixture and to supply the voltage to the tube from the fixture's ballast.
Fuse is used to restrict the flow of current to the tube when it is supplied with very high voltage. Due to high voltage the tube may burst and even the electrical apparatus goes malfunctioning. Hence a resistor is used in the name of FUSE in the fluorescent lamp to prevent this sudden loss of the apparatus.
it will not glow
You can use a wire instead of the starter to test the tubes .. I did it, it works !
To limit the current flowing through the fluorescent tube once its gas has ionised.
11000
A choke coil, also known as a ballast, limits the current to a fluorescent tube by providing a high impedance to the flow of current. This high impedance restricts the current flowing through the tube, allowing it to operate within its required current range. The choke coil also helps regulate the starting voltage and stabilize the operation of the tube.
The thick smoldering smoke of the fluorescent fire was enough to make him choke.
six main component of fluorescent tube light
A four tube fluorescent luminaire is just 4 separate fluorescent lamp circuits in one fitting. Look up 'how things work' etc to see a fluorescent lamp circuit.
Soak in diesel overnight to loosen dirt/debris, use choke key supplied with gun
Same choke tube as a 1200 or 1400 pump
444
wiring diagram of electronic choke in tube light
The choke you use depends on your target rather than the type of shotgun. For example: if you are shooting skeet, you would use improved or modified cylinder, but if you are shooting trap, you would use full choke.