What would you like to do?

Heat loss in copper pipes?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

The thickness of the pipe will effect the loss rate.
Best thing to do is buy thermal isulating foam, normally comes in tubes will a slit down one side so it can be slid over the pipe easily. Also depending on the the fluid inside the conduit ( pipe ) and diameter, ambient temp, and location, you may be able to use a product such as heat trace. It is an electrical wrap that uses voltage and amperage to create heat to shield from the outer elements...
7 people found this useful
Thanks for the feedback!

Why is copper used for heating pipes?

Because it is EASY to use FAST to install gives up heat faster then steel or cast Iron and just about anyone above the age of 4 can solder it and it is light to handle

Formula for Heat loss in a pipe?

pips are generally cylindrical in structure of amount of heat loss through pipe is given by the formula   Q= 2 pi k L(T1-T2)/ln(r2/r1)   where   k=conductivity of mat

How do you connect a PVC pipe to a copper pipe?

I've seen fittings for that situation in the plumbing section at home depot. Most hardware stores should have those fittings. I would be careful not to heat up the PVC too muc

How do you weld copper pipe to copper pipe - not brazed?

tig or mig depending on the wall thickness Copper to copper is either soft soldered, or silver soldered Silver solder is a bad term as "solder" normally means lead content a

Galvanised pipe to copper pipe fitting?

You will want to put a length of copper into the fitting and solder it before you put it on the galvanised so that you don't cook out the pipe dope. >>they also could have so

How do you join copper pipe to copper pipe?

In some applications, copper pipe can be TIG or MIG welded to copper pipe or to fittings. One example might be in antenna construction, but this is not what we usually encount

What is heat loss formulae of water flow through PPR-C pipe line?

you have first to know the thermal conductivity of PPR that you are dealing with. normally, this is in range between 0.1 to 0.24 W/MK .then you apply this formula Q(IN WATTS)

How do I install copper piping to pex piping?

The copper should fit in the Pex fitting. My mistake, Pex uses the crimp rings. There is a coupling and other fitting that you just push the pipe into and it grabs and seal th

What is copper loss?

Copper loss is the term often given to heat produced by electrical currents in the conductors of transformer windings, or other electrical devices

How do you connect a lead pipe to a copper pipe?

You should not connect a lead pipe to any pipe. Lead is not legal to be used for any pipe anymore. If performing a repair on a waste line lead and copper can be joined by a ru

How does copper get turned into a copper pipe?

Modern seamless pipe is extruded. The process starts wit a large cylindrical ingot like a big fat copper washer being forced through a a smaller diameter die to create a small