While holding the "A" trip meter button down, turn the ign switch to "on" ( not start). Hold the trip button down and watch the trip meter count down from - - - - - , - - - - , - - - , - - , - . That's it.
How to Reset Maintenance Warning Light on a 2008 Toyota 4Runner
Check your owners manual
Im not sure about the 2008 but on my 2006 all you need do is hold down the trip odometer then turn the key to on. Watch screen where the miles add up. Hold the button down till the screen is blank.
If you have one it's on the drivers side up under the dash by your right knee.
how down the reset button approximately 15 to 20 seconds...then you would notice the maintenance lights flashes. at that time, just press the reset button once more. that's all to it.
With the ignition off, push and hold the odometer reset button, now turn the ignition on without starting the engine. After 5 seconds the maintenance required light will go out and reset.
Disconect battery for 5 minutes. Disconnect the battery for 5 minutes. Should reset engine light.
Not in the manuel, manuel-is closely guarded by MB for selfish reasons.....
Turn on Ignition - depress gas pedal 3 times
To reset "Maintenance Notice" on the display, turn the ignition key to ON, with engine off. Select the "Maintenance Schedule' key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button.
How do you reset 2008 honda element service light?
To reset "Maintenance Notice" on the display, turn the ignition key to ON, with engine off. Select the "Maintenance Schedule' key by using the button to right or left. Using the button select the "Reset" key and push the "Enter" button.