Show how to replace drivers side window?

Answer 1

OK, most cars its really easy, just a few steps you have to go through. FIRST, if you are replacing a window odds are the old one is broken, so take off your door panel (usually a screw on the door handle surround, its kinda hard to see sometimes), and the if you have roll up windows take a rag and point the window handle down, and stick the rag under the handle base and wiggle it in a U pattern and it will snag the little clip holding the hanlde. SECOND, Once you have you the door panel off peel back the plastic(its a plastic sheet, keeps the water out) once you get it out take a vacuum and get out all the broken glass out of it, and take a flathead screw driver and get the glass chunks out of the window channels. THIRD, once you have all the old glass out, roll down the window and look for a bar that goes horizontal(it typically has 2 bolts on it and will have the rest of the glass attached to it) and take that off and trash it(keep the bolts). FOURTH, grab the new window and put it into the channel with the smaller end down(front) and kinda work it into place. once into place guide it down and line up that horizontal bar, and bolt it in place. FIFTH, test it out and if all is good put it all back together. DONE!!!!

Answer 2

Remove the inside door panel. Remove the window retaining clips. The window will slide out. Reverse the process to install the new window.