The easiest way to reset a service lamp on any vehicle is to disconnect both battery terminals first. Run a wire across both battery terminals and leave attached for at least a couple of hours. Detach the wire and reconnect the battery terminals. Your service light should now be out.
Make sure that you do not run the wire across the positive and negative terminals of the battery. Make sure you disconnect both terminals and run the wire across the cables and not the actual battery terminals.
If your service engine light is on it means your computer is registering a code. Make sure you take your car to have it diagnosed properly instead of resetting the light. It may be a serious code that could cause problems in the future.
according to autodata service lamp can only be reset using suitable diagnostic computer Dr.Pedro VolksWagen service technician
what year or VIN no is your sprinter
with the switch off, press and hold the odometer button. Turn the switch on, and the odometer will be in insp mode. mode. Press the odometer button until the indicator shows --- . Turn the switch off and the lamp should be reset.
how to reset service to next service
To reset the oil change lamp on a 2007 Town and Country, locate the reset button on the instrument panel. Hold the button down for 5 seconds.
The SRI lamp may only be reset with the use of a DRBII scan tool, or equivalent. If this is not available, you will have to take the vehicle to a properly equipped shop for them to reset the lamp.
There's no great ''trade secret'' as to how to reset the service indicator lamp on most Vauxhall's, simply refer to pages in the Owner's Handbook! For reference of those interested in such matters, but who might not have access to an owner's manual, this is the procedure to follow: Vauxhall service reset * Turn Ignition Off * Hold Trip Reset In * Turn Ignition On Still Holding * Trip Reset wait for three dashes * Turn off Ignition * Turn on Ignition to confirm To the best of my knowledge, the above service light reset procedure applicable to most Vauxhalls HOPE THIS SAVES YOU PAYING FOR INFORMATION!!!!!!!!!!!!!!!!!!!! ;-)
how do i reset service settings on c200 kompresor
Remove the negative battery terminal (-) for about 15 minutes and most codes will reset.
> Resetting service reminder: 1. Press and hold rear fog lamp switch 2. Turn ignition on, do not start engine 3. Release rear fog lamp switch 4. Press and hold trip button (end of left side stalk) 5. Press and hold rear fog lamp switch 6. See "Resetting Service Light" message in message center
Press and hold the right button. (odometer reset) now switch on the ignition (oil lamp will not flash, but on at all times) press the right button again (insp is now displayed) pull left button. (clock set) (------ are now displayed) Pull left button again This works on my A4 tdi (110bhp) but should work on all. ALTERNATIVELY: Press and hold Service button, switch on the ignition. When the service message appears on screen - press 0.0 (odometer reset). That should reset your 'service!' message.
Hiw do you reset a service light j2