You just Calculate Size of Bus bar which has been mentioned below:
Example: Calculate Size of Bus bar having Following Details
The lap length for welding a reinforced bar will depend on the size of the bar that is being welded. If the bars are different diameters when lapped, the lap length should be calculated using the lesser diameter.
1 bar = 14.5 PSI
Pounds per Square Inch or Psi is a unit of pressure or stress. 1 bar is equal to 14.50377 Psi.
You take both balls on the ends off. Take out the bar. and place a new one in. and then put the balls on the end of that bar.
1 bar is 14.5038 psi. Scroll down to related links and look at "Conversion of pressure or stress units".
Earthing busbar size
To obtain the amp of the copper bus bar, multiply the width of the bus bar by the thickness of the bus bar to obtain the current carrying capacity of the bus bar.
5-6x150 Cu. BUS BAR PER PHASE
You first have to find out what the load amperage is going to be and second, what is the working voltage.
TMT bar oval weight Stand oval size in mm like 12mm size bar oval size-12*.8=9.6kg/m
Busbar Length x Busbar Size x 0.009 ex- Length= 12meter Size = 60 X 10 mm ie, 12 x 60 x 10 x 0.009 Ans = 65 kg Can you please let us know what is "0.009" for??? Ans: 0.009 = copper density Max. Current for 60 x 10mm = 60 x 10 x 1.55 = 930 AMP What is "1.55" for??
Single bus is used in smaller, less important substations. A fault on the bus requires tripping of all lines into the bus. When higher redundancy is necessary, ring and breaker and 1/2 schemes are used. These are the three most common.
The term "bus bar" refers to a strip of bar of brass, aluminum, or copper. This strip of bar conducts electricity with a distribution and switch board.
Bus bar is a physical component that carries the current. AMP is unit of current. They can not be converted
...because it is an infinite bus bar, meaning it can supply infinite current. By Ohm's law, since the voltage at the bus bar is fixed, to have infinite current, you must have a zero impedance.
Bus bars are actually simple conductor strips of copper using for connection between one system to another.for example transformer to panel. bus ducts are enclouser of that bus bar
voltage of incoming machine should be same as that of bus bar voltage