You need to purchase a Haynes Manual that is specific to your car. They can be bought at a parts store or bookstore.
You will need: Jack, jackstands, various wrenches or socket set, new brake pads, c-clamp
I usually do one side at a time.
Jack the car up safely. Put the car on jackstands.
Take the wheel off.
Loosen the two caliper bolts.
Pull the caliper off, and remove the old pads.
Make sure you DONT let the caliper hang by the brake cable set it up behind the knuckle or get something to support it with.
Use a large C-clamp to push the piston back in.
Install the new pads on the caliper.
Put the caliper back on, tighten the bolts down.
Replace the wheel.
Move on to the other side. Repeat procedure.
Check brakes before going anywhere!
Brake light switch on the brake pedal is defective
Joey AF R.
Replacing_a_rear_light_bulb_on_a_1999_monte_carlo_where_do_you_go_to_access_the_rear_right_light
video to learn how to replace the engine gasket..upper & lower gasket for 1999 Monte Carlo.
Water pump removal chevy monte carlo 3.8
Bolts on the caliper of a 1999 Monte Carlo will loosen to the left and tighten to the right.
where is the vaccum canister located on a 96 monte carlo
How do i replace the purge valve on a 1999 Chevy Monte Carlo
if im not mistaking the controls on the radio.to change the settings
They sure do.
Yes, there is virtually no difference in the dimensions and installation hardware of body parts between 1995-1999 Chevy Monte Carlos.
I doubt it as they changed the body style in 2000.