THE FUEL PUMP IS LOCATATED IN THE GAS TANK (should be plastic tank). Tank must be lowered from vehicle. Do not try to remove tank with gas in it! Gas can be siphoned out through filler hose/grommet. Tank is held up by straps.Spray nuts with penatrating oil(PB Blaster).Due to the length of the bolts you may have to make a tool that will allow you to remove nuts or find a really deep socket. Filler hose/grommet should be replaced.(Compare new unit to old) Fuel pump-filter-sending unit is serviced as one unit.Clean dirt off to avoid getting it into tank.Unscrew large plastic ring ,remove unit,(check for dirt in tank & remove) install new unit..Re-install tank.Be prepared to replace bolts that hold straps up.
Cap and distributor / rotor system
No, Dodge does not use inertia/reset swithces.
Change the canister.Change the canister.
junk yard
The 318 provides about 230 HP while the 360 provides about 190hp
A Dodge B250 Van does not have a mass airflow sensor.
Under the hood, in the black box near the battery
I have a 1989 Dodge B250...it has overdrive
No.
No.
Center of the firewall.
Yes