remove spark plug wires from connectors on valve covers. on the rt vlv cover, remover EGR valve from the exhaust manifold. remove belt and the alternator rear brace, then move alternator towards the fender. remove valve cover bolts. detach valve cover.do NOT pry on the cover. if its stuck, use a block of wood and a hammer to remove it. INSTALLATION the mating surfaces of the cylinder head and valve cover must be clean. use a gasket scraper to remove all traces of sealant and old gasket. the covers are aluminum so do not nick when scraping them. place covera nd gasket in place and tighten in several steps, little bit at a time, to torque specs (89in-lbs). do NOT overtighten. replace the EGR, alternator brace, belt and plug wires. start and check for leaks.
valve cover gaskets, front main seal, rear main seal, timing chain cover gasket, could be any of these. ... How would i change a valve cover gasket on a 96 camaro rs. Their is a steel plate in the way on the left side.
Remove the valve cover.....scrape off old gasket.....clean gasket surface on valve cover....apply gasket sealent to valve cover gasket surface.....set gasket in sealent.....reinstall valve cover.
hoe tdo you change a valve cover gasket on a daewoo nubira
how to replace valve cover gasket toyota rav4 2001
how do you change valve cover gasket 2004 hyundai elantra
how do i remove the valve cover to change the gasket in a toyota camry 1996
The valve cover gasket on a Harley 883 motorcycle is changed by unbolting the valve cover and lifting it from the engine. The gasket can then be removed, the surface cleaned, and a new gasket put in place.
you should only change the gasket if you have to take the valve cover off....... you should only change the gasket if you have to take the valve cover off.......
i am going to change the valve cover gasket on my 97 cadillac catera, what do i need to remove and do? Is it hard?
The valve cover gasket on a 84 Infinity G20 is changed by removing the cover bolts and prying the cover off. The old gasket is removed, the surface cleaned, and a new gasket put in place.
how to change a valve cover gasket on a 97 mercury grand marquis ?
The intake may have to be removed to gain access. The valve cover just bolts on. When putting a new gasket on clean all of the old gasket off and try not to scratch the head or valve cover.