Under the hood of car from the back of the headlight, release/flip the two retaining wires holding the cover over the lights and remove cover, unplug the wire harness from the bulb (there is a clip on one side), remove the black retaining ring that secures the bulb in place by turning it counter-clockwise, slide bulb out from the rear, replace with new bulb (careful not to touch bulb with fingers as dirt and oil will shorten the life of the bulb), assemble in reverse manner. This is for replacing bulb only.
Note that on the driver's side there is a bulb access plate held on by two Philips head screws. This side is the same as the passenger side but has very little room due to the battery cover. You may need to remove the battery cover assembly in order to get to the bulb. Be patient. Use a pair of needle nosed pliers to unclip the cover and the wire harness.
Even with the limited access both bulbs can be changed in under 30 minutes.
Could you please tell how I change a headlight bulb for my Volkswagen T4 panel van
See Here: http://wiki.answers.com/Q/How_do_you_change_a_1999_vw_head_lamp
The headlight bulb on a Volkswagen Polo can be removed by grabbing the back of the headlight bald and pushing forward and turning at the same time. The bulb will come out. Reverse the process to install the new headlight bulb.
I DO NOT KNOW IF I WAS A MECHANIC I WOULD BE WORKING AS ONE
It should be the same as a '99. See here: http://wiki.answers.com/Q/How_do_you_change_a_1999_vw_head_lamp
There are plastic clips that rotate on rear part of headlight under hood that release the assy then the whole thing slides forward out the front of car.
How do you I change a headlight on my Camry
How do you change headlight on suzuki xl7
How do you change the headlight on a 240D mercedes?
how to change a headlight on a 2003 passat
How do you change headlight on suzuki xl7
My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb? My headlight is not working on the passengers side. Do I need to change out the headlight assembly or can I simply change out the bulb?