easy, open ur trunk and directly behind ur tail light (in ur trunk) u sell a carpet cover line tha inside of ur trunk corners pull and untuck that off slighty and ull see the back covers to ur tail lights and reverse lights..twist off, remove the remove bulb but twisting it and pull in out...
you DO NOT disassemble the lens cover!!!! Open the hatch, and you will see small access panels directly behind the taillights that open. Just open the panel and take the bulb out.
You have to go inside the trunk and remove the circular plastic covers from behind the lights. Then you have to unscrew the entire light and you can access the bulbs to replace them.
My 2007 Mazda 3 has very detailed instructions on how to do so...check your owner's manual to see if its the same situation on the 2005 RX8. See sources and related links below for more information on bulbs.
How do you remove cover to replace brake light on 57 kia Rio
push it forward the it should come off
I own a 2006 Mazda Tribute I. I am not a mechanic but I recently adjusted my E-brake, and this what I discovered... The E-brake adjustment nut is located under the E-brake leather cover (directly to the left of the E-brake lever). You have to remove the E-brake cover and tighthen the bolt to the proper adjustment.
To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.
You must remove the entire light assembly as follows: Lower the tail gate and remove the two small screws that screw into the side of the assembly. Next remove the two screws on the outside of the assembly that are accessible through long holes on the outside of the assembly. Pull the assembly back to expose the rear where the lights are located.
you have to kneel on the back seat and remove the cover from the rear deck.the bulb socket is turned counterclockwise and the bulb can be replaced.
There is about 12 bolts on the underside of the bumber cover that you must take out. Also, 4 up top and 1 or 2 in each finder well. Have fun....
To replace the rear brake lights on a Nissan Primera first open the trunk lid. Locate the tail lights and find the plastic cover which hide the bulbs. Remove the cover and then the bulb. Replace with a new bulb.
Pop the trunk, behind where the brake lights are, there is probably a plastic/rubber cover with screws in it, remove it, and then there should be some screws holding the lens in place, remove those, pull the brake light lens from the outside of the car, twist the wires to undo them from the lens, and go from there.