answersLogoWhite

0


Best Answer

on my 99 rodeo, this problem was caused by the fuel indicator located inside the fuel tank and part of the pump - you need to replace the entire pump which entails dropping the entire tank

User Avatar

Wiki User

17y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you fix gas gauge in 1999 izuzu rodeo the light stays on and gauge needle goes back and forth?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you know if Oldsmobile intrigue is overheating?

The gauge on the far right side of the gauge cluster is your engine temperature gauge. The normal operating temperature is at the half-way mark. If the needle raises above the 3/4 mark then the car is overheating. A light will come on also if it begins to overheat.


What is the second needle situated on the speedometor symoblised for on a peugeot 306 meridian?

I am pretty sure you are talking about the oil level gauge which comes on when you start the car. Once the engine is started, the gauge drops back to 0, and the light behind it will go off.


What makes the check gauge light come then the battery gauge rolls from side to side?

What year is your car? Did you mean the CHECK ENGINE light? The battery gauge?


Rodeo Izuzu starts acting up staling check engine light comes on and the reduced power light...whats going on anybody have this problem?

I am having the same problem and the mechanic can't figure out what is wrong


Can you 14 gauge wire from the panel box to 12 gauge wire to the light?

no


Will a 16 gauge forearm fit on a light 12 gauge browning a5?

No


Where is gauge for 1998 Kia Sportage 4x4 Transmission?

What gauge, there is no gauge, there is an illumination light that tells you your in 4 x4 mode, no gauge though.


What is the general prep for a needle biopsy?

eat a light meal


How do you dignose the interior light fuse keeps blowing out and what is the amp for that fuse?

Easiest way is to get a "short finder kit" This consists of a automatic reset circuit breaker to install in place of the fuse, and a small magnetic amp gauge that you hold in your hand. You can get these at a automotive store or a tool guy such as snap-on or a Mac dealer. You install the circuit breaker and it will click on and off about 1-4 times a second while short occurs. You hold the amp gauge near the circuit wire that is shorted and watch the needle fluctuate back and forth. when you pass the area of the short, the needle will stop moving. You have located the short where the needle stops moving. You can use the gauge near pillar posts and body metal also and it will sense the wire even through car metal. The objective is to find where the wire is shorted in the car body or location. Most shorts are found where the wires are EXPOSED and not inside pillar posts or body parts where you can't access the wire harness. Interior light fuses are mostly rated for 10-15 amps.


Renault mengane fuel light always on gauge not working?

fuel gauge not working


Where is the location of the check engine light on a 1996 ford ranger?

Check engine light : Gauge cluster without tachometer ( under the engine oil pressure gauge ) Gauge cluster with tachometer ( just to the left of the battery voltage gauge )


What would make check gauge light come on in 1999 Chevy Tahoe?

Check gauge? Never heard of a check gauge light. If you are referring to the check engine light it is on because there is a problem with the emissions system. You need to have the ECU scanned by a professional.