Saturn Shop Foreman here, old school GM window crank remover or use a shop rag behind the crank to grab the tangs of the clip and pop it out, it will fly like the wind if you don't watch out!
behind the window crank handle, there is a horseshoe shaped pin, pop that pin off and the crank handle should pull right off.
behind the window crank handle, there is a horseshoe shaped pin, pop that pin off and the crank handle should pull right off.
Remove the inside door panel of your 1997 Chevy Lumina. Remove the linkage to the window crank. Remove the window crank retaining bolts. Reverse the process to install the new window crank.
You need a special tool to remove it . The tool slides between the door and the handle and pushes the clip out
yes
You can remove the window crank handle by just using a simple shop rag. How you do this you slide the rag(unfolded) between the door panel and window crank and rotate around the window crank until you snag the clip that is retain the window crank. The clip is a simple wire clip shaped like a "C" To reinstall you place the clip back in the groove on window crank and press back on the window regualtor shaft
The crank sensor is located in front of the oil pan underneath the car.
the crank sensor is located on the top front of the tranny
Window cranks are easy to remove. Go to the local auto parts store, and ask for a window crank removal too. Slip it in behind the crank until it comes free.
crank sensor is bad
You would need to remove the window regulator, and the motor. Replace them both and drill a hold through your door panel where the crank will come out.
This page will tell you how to do this......good luck. http://www.maintainyourcar.co.uk/1999_hyundai_accent_window_winde.htm