There is a tool used to twist the piston back into the caliper I bought mine from Canadian Tire.
If you do not want to spend any money, then, put the old pads in and use a bar or screw driver to force the pistons back................BUT, in all good sense, just go to your local auto parts and buy a small tool that will do the job for you. It is not expensive, then put the old pads in and put the tool between them, and just turn the screw. It will force the pistons back with no damage. If in the event the pistons are very hard to retract, then I would suggest to replace the calipers. Good luck.
I go to AutoZone and borrow their caliper compression tool. Follow the instructions closely. The piston is screwed in with the tool in a clockwise rotation.
Remove the wheels RE-install 2 lug nuts to hold rotor in place Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body Replace inner and outer pads Re-install caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE Remove the wheels RE-install 2 lug nuts to hold rotor in place Remove caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body Replace inner and outer pads Re-install caliper PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
Remove wheels Loosen 2 Caliper mounting bolts Remove only one to allow caliper to swing away from rotor Remove rotor Remove outer brake pad Use "C" Clamp to retract piston into caliper body Remove inner pad Replace inner and outer brake pads Replace rotor Resecure brake caliper BE SURE TO PUMP BRAKE PEDAL PRIOR TO MOVING VEHICLE TO SET PADS AGAINST ROTOR
7MM
caliper bolts are the two bolts that hold a brake caliper to the caliper mounting bracket. On both the front and rear of the vehicle (unless has rear drum brakes) the bolts have rubber boots around them working as slide pins.
The Detroit Pistons! The Detroit Pistons!
simple. get yourself a wrench set and an actuator tool to push in the rear pistons on the calipers.
Front caliper bracket to knuckle, 85 ft lbs. I also use a drop of blue "Loctite" thread locker on clean threads.
Larry Brown led the Detroit Pistons to an NBA championship in 2004.
Brake rotor? Should be "peel off" type Raise and support vehicle Remove wheel Remove caliper mounting bolts Slide caliper off rotor Slide rotor off hub
it's a 3/8 wrench for both 2003 and 2004 caliper.