This is a quick answer. Its above the starter going into the side of the block. (front side of the engine) Disconnect the battery. Remove the starter. Remove the wore plug into the sensor. The sensor has 1 bolt holding it in. Remove the bolt, you may have to wiggle the sensor at the base a bit as you pull it out. Replace, and make sure it is pushed in all of the way. Replace the bolt, wire plug, starter, reconnect the battery. If you have ever removed or replaced a starter this is cake, that is the hardest part of the job. Rich
The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.
How do you install crankshaft position sensor 95 BENZ C220?
where is the crankshaft position sensor on a 2004 maxima
I have a 98 olds intrigue...the camshaft position sensor is located around the middle polley on the left side of the engine. It has one screw. It's fairly easy to install.
You must remove the fuel tank in order to access the fuel pump.
It takes a special gauge to install the crank sensor. It can be rented from some parts stores.
ramdom much
You will need to remove the water supply hoses from your 1998 Oldsmobile Intrigue heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
CRANKSHAFT POSITION SENSOR The crankshaft sensor is located on the passengers side of the transmission housing, above the differential housing Crankshaft Position Sensor The bottom of the sensor sits above the drive plate REMOVAL Disconnect electrical connector from crankshaft position sensor. Remove sensor mounting screw. Remove sensor. INSTALLATION Install sensor and push sensor down until contact is made with the transmission case. While holding the sensor in this position, install and tighten the retaining bolt to 12 N·m (105 in. lbs.) torque. Connect electrical connector to crankshaft position sensor.
Unbolt front flange from exhaust pipe Cut or unclamp rear from tail pipe Replace with new converter
right above the oil filter
Pull the plastic trim that surrounds the radio and center stack, remove the screws that hold it in, pull it out and unplug it. Reverse to install.