There are some different engines. This is for the 3.8 liter vin K engine. belt/pully routing- Over top of Alternator to: top of A/C compressor and around right side to: bottom of crankshaft and up left side to: right side of water pump, over top to: right side and over top of tensioner then: down to right side of Power Steering and around the bottom and up left side back to the alternator. The above routing is also true for the vin 1 engine, as I was very pleasantly surprised to find out after removing the alternator & forgetting the routing.
The 1995 Oldsmobile serpentine belt routing diagram can be obtained from most General Motors dealerships. The diagram can be found at most auto-parts stores.
Yes, there is a diagram for a 1995 Dodge Spirit Serpentine Belt Diagram. It is found in the maintenance manual to the car.
You can get a serpentine belt diagram for your 1995 Eagle Talon at most Chrysler dealerships. Most auto-parts stores will give you a diagram when you purchase the serpentine belt.
There is a diagram, for the power window system, for your 1995 Oldsmobile. The diagram can be obtained from most General Motors dealerships.
There should be a diagram for that under the hood. I have one on my 96. You will have to loosen bolts for the AC and generator/altenator. Then retighten them after install and pull/pry them to put the tention on the belt. There is a National Aurora Club web site too. just add a dot com to that.
The 1995 Cadillac serpentine belt routing diagram can be obtained from most Cadillac dealerships. Most service manuals will show the routing diagram.
A diagram for the serpentine belt for the 1995 Bonneville can be found in an Chilton's manual for that year and make of vehicle. The belt diagram varies depending on the exact vehicle engine type.
http://tech.bentleypublishers.com/servlet/JiveServlet/download/73-16156-142538-1636/Alternator%20drive%20belt,replacing%20(M62).pdf Here is a helpful link on the routing diagram. But it is called a drive belt instead of the s belt or serpentine belt.
Look under the hood of the car for the diagram or in your owners manual if you have it.
you will find a diagram on the packet when you buy a new belt. there is also a diagram in the owners handbook
autozone
there is not a specific torque for the idler pully. tighten it up with a ratchet and it will not loosen up