(1) Connect positive cable to positive post of battery that is being jump-started (2) Connect opposite end of positive cable to positive post of battery that is doing the jumping (3) Connect negative end of cable to negative post of battery doing the jumping (4) Connect opposite end of negative cable to GROUND on vehicle being jump-started. Be sure and connect in the order indicated (1-2-3-4). To disconnect cables after jumping, reverse the steps (4-3-2-1). Following the above order of connecting and disconnecting will prevent any sparking or arcing that might fry the ECU or other electronic components.
How do u jump start a 2007 BMW 525i
yes
The same way you jump start any other car.
with a key??
There are several things that can cause your 1992 BMW not to start. Make sure the battery cables and battery posts are cleaned. Make sure the battery cables on the starter are tight and clean.
use jumper cables Moran
it has a jump start connection at the top left hand side of the engine. if you have the manual it will show exact location...
A BMW 530i is jump started by connecting the cables to the positive leads on both vehicles. The negative leads are connected to strong grounds like the alternator bracket.
There is a jump start terminal under hood with a red plastic cap on it. Ground can go on bolt right next to it.
A BMC 7 series is jump started by connecting the positive lead to the donor vehicle and the BMW. The negative leads are then connected to bare metal and the vehicle started.
Take Another Car and Wire Their Batteries TogetherThen start The Car And Your Battery Will Recharge A Littleenough to go to a BMW dealer or autozone shop.
You would jump it much like a standard car but you would park the working car behind the BMW Z3 because the battery is in the trunk under the trunk mat. BMW does this to create more even weight distribution in the car.