answersLogoWhite

0


Best Answer

You can use a jack to lift it but make sure the decks footings are able to be lifted and aren't screwed in to something that won't move with the deck. Also make sure the jack is on something solid like concrete, 2x10, 12x12 paver stone, etc. something that won't compress.

ideas-for-deck-designs.com

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you lift the deck?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about General Arts & Entertainment
Related questions

How do you replace a deck lift cable on a cub cadet?

To replace a deck lift cable on a cub cadet lawn mower you can easily remove the two bolts underneath the deck that hold the lift cable in place and then replace the cable.


How do you lift up the mower deck on John Deere F620?

lift the yoke gaurd door and make sure that the front yoke is turned so that the split side is up, then pull the rotator handle. the deck will then drop. then make sure that the mower deck is at the lowest position. go to the front of the mower deck and lift by the two handles until it locks in place. the locking pin is on the left side as you face the mower from the front. be prepared it weighs about 175 lbs. these instructions apply to the 60" deck. good luck.


Does the front deck wheels on a badboy mower need to ride the top of the ground?

Most often deck wheels ride 1/4 - 1/2" above the ground and lift the deck to try to prevent scalping.


Deck joists that cantilever out past the deck posts should never overhang the girder they rest on by more than?

Deck joists can lift out of their hangers at the rim/band if too many people are at the cantilievered section of a deck. Therefore deck joists that cantilever out past the deck posts, should never overhang the girder they rests on by more than how far?


Where is spare tire in 2006 Mustang located?

There is a 'donut' spare under the trunk deck. Lift the trunk carpet from the corner.


Deck joists can lift out of their hangers at rimband if too many people are at the cantilievered section of deck Therefore deck joints that cantilever out past the deck posts should never overhang t?

The answer requires more information. Joist depth Joist spacing Wood Species Engineered wood will be based on the manufacturers information. Hope this helps! TL North, CBO


Build A Deck Frame First?

When you are building a wood deck on ground, you need to build a frame first. This will lift the deck boards themselves up off of the ground. This helps to allow air to move under them so that moisture does not build up. It also allows runoff from rain or snow to move under the deck without becoming trapped. The frame provides support, and it can also make the deck itself last longer.


How do you install deck belt on 46inch huskee lawn mower?

Remove the deck. First by pulling the pins that attach the lift brackets, and then remove the rear spring, and the 2 belt guides under the engine for the belt that drives the deck (1/4" socket). After the deck is out, release the spring that applies tention on the right idler pulley (you'll have to remove the 2 side pulley covers).


Replace back speakes in 2001 alero?

if your speakers are housed in a molded deck, you will have to flop the seat backs down, then you will see black upholstry plugs that secure the deck across the top lip of the seat back (four or more) then inside the trunk you will see two clops that drop through the metal deck , just gently release these with a screwdriver and the whole deck will lift out , but you have to do both sides ...try that


How do you level cutting deck on Yamaha lawn tractor?

Ensure the engine is cool and disconnect the spark plug wire. Put the deck lift lever in the middle. Find the height of the front blade tip to the ground. Tighten the hex nut and loosen it again to lower the deck front. Adjust the deck by relaxing the bolt on the left hunger. Ensure both blade tips have equal measurements.


How do I remove deck from 2554s John Deere lawn tractor?

release the belt tensioner bar on the right side of the deck. you can do this by hand, it is the rotating bar that is held back by a catch on the deck. at the front of the deck where it is attached, rotate that bar downward to release it. at the rear attachment points on each side, you will just pull out on the round metal peices that stick out of the side of the frame. if they wont pull, you may need to lift up on the deck lightly to lessen the tension. pull the belt off that connects the deck to the mower and slide the deck out sideways. once you do it one time you will be able to do it in five minutes


Poulan Riding mower 17hp 42 cut and a spring came off during mowing It obviously has to do with the blade deck as it now cuts to the groundAnyone know where spring goes?

I think your mower deck lift assembly spring has fallen off. The spring came off because the deck lift adjustment screw must have been unscrewed to the point that the deck fell off. Cut and paste this address into your browser address bar. You will need to prop the deck up put the spring back on and screw the adjustment screw back together. Keep in mind the adjustment screw may have fallen off completely. http://www.partstree.com/parts/?lc=poulan_weed_eater&mn=PP12542J+Tractor&dn=0825730010