This is how it is performed on my 2000 Buick Regal LS
1. Sit in the driver's seat.
2. Close all vehicle doors.
3. Insert the key into the ignition and turn the key on, (DO NOT START) and then off.
4. Remove the key from the ignition.
5. Press and hold unlock on the door lock switch. DO NOT RELEASE UNTIL STATED
6. While holding the door lock switch in the unlock position, insert and remove the ignition key twice. Do not rotate the ignition lock cylinder.
7. Insert the ignition key a third time leaving the key in the ignition lock cylinder.
8. Release the door lock switch. You will hear three chimes. This chime feedback indicates that transmitter programming is active.
9. Press and hold the lock and unlock buttons at the same time on the keyless entry transmitter for 12 to 15 seconds. You will hear two chimes. This chime feedback indicates that the transmitter has been programmed successfully.
10. Repeat step 9 for the rest of the transmitters (for a total of 4 transmitters).
11. Exit this procedure by removing the ignition key from the ignition lock cylinder.
Answeryou will need the dealer tech 2 scan tool to do this AnswerAssuming you have "Pass key III", there is another way. The procedure that the manual recomends is for when the battery dies and your fob goes brain dead as a result. For lost fobs it's recommended that you get your car and fobs reprogramed so no one else can easily get at your car. The quick test to see if your fob needs to be resynchronized is to press the instant alarm (red horn symbol button). If that works and nothing else then resynchronize. Take your brain dead fob and press both the lock and unlock buttons simultaniously within range of the car. The manual says this should take about 8 seconds. Once the car has re-awakend your fob, the locks will cycle and what ever else your car has been programed to do when it locks and unlocks.how do i program keyless remote for 2000 Buick LeSabre
By braking it down and fixing all parts
YOU WILL HAVE TO USE A GM PROGRAMER TECH 1 OR TECH 2 I DON'T REMEMBER THE YEAR BREAK
yes it wont allow your compressor to run
Follow this link and you're good to go. Let me know if you have any questions. I've done this myself so I know how to do it. .ehow.com/how_7291758_program -remote-1997-buick-lesabre.html#ixzz1HA YkCKDX
How do i program my remote car starter / lawless remote
In the owners manual it tells. On my 93 lesabre I had to jump two of the connetors on the code reader
Ign off, On the data link connector use a wire to jumper terminal #8 (black/white) wire to #4 (black) wire, Turn Ign on press and hold unlock and lock button on one transmitter locks will cycle, repeat for second transmitter, disconnect wire, should do it. That is basically correct but there are more detailed instructions with a diagram at the following site: How to Program a Replacement Keyless Remote on a 1997 Buick LeSabre | eHow.com http://www.ehow.com/how_7291758_program -remote-1997-buick-lesabre.html#ixzz1HA YkCKDX
Take it to your Buick dealer is how.
You can do it but be careful not to break the prongs
Sell It!!
Where is the thermostat located on a 1987 Buick LeSabre?