There is a tensioner located towards the front of the engine. You'll need a fairly long handle ratchet, a breaker bar preferred. In any event you'll have to determine what on your model has to grab a hold of, release the tension and slide the belt off of which ever pulley is close. Then relaese the tension SLOWLY!!! there is a lot of tension on it and it could snap out of your hand. then reverse the process only retract the tensioner at the end when your ready to put the belt on your last pulley.
Need to know where is the thermostat located on a 1996 mercury tracer.
Need to know where is the thermostat located on a 1996 Mercury tracer.
where is the transmission fill on the mercury tracer
A broken serpentine belt.
On the Firewall
the alternator will be on the end of the engine that has the drive belts or serpentine belts, alternators are belt driven.
on the starter motor.
On a 1996 Mercury Tracer : Both the 1.8 and 1.9 liter four cylinder engines are ( fuel injected ) so there is ( no carburetor )
On a 1996 Mercury Tracer : Both the 1.8 and the 1.9 liter four cylinder engines are fuel injected so there is no carburetor
The tranny ( or transaxle / transmission ) on a 1993 Mercury Tracer is in the engine compartment bolted to the engine on the drivers side of the engine
Mercury Tracer was created in 1987.
A speed sensor on a 1998 Mercury Tracer is located on the transmission housing of the vehicle. It is placed on top in a secure location to safely measure the speed the transaxle spins.