On the 2008 Liberty there are one screw and one bolt that need to be removed. The Torx head screw is located in the bottom corner furthest from the door hinge behind a 1/2" diameter plastic cover. The bolt is located behind the pry off cover over the interior door release handle. This bolt head is 10mm. The door handle cover should be pried on the edge closest to the door hinge. You may see a small access point for this purpose. This cover has one push in type fastener near the edge. After the screw and bolt are removed, the entire panel should be raised upward to release the "hook" type holders. Just give the panel a rap with the palm of your hand upward from the bottom edge. Do not try to pry the panel off straight away from the frame you will damage the panel holders. The holders/fasteners are not push in type except for the release handle cover.
I just pops out
My 2006 Liberty has four cup holders - two in the center console and one in each rear door panel.
driver side on left side of dash/steering wheel - remove panel on side
you need to remove the inside door panel to get access to the inside, remove the clips holding the door handle assembly and the whole thing comes off
Remove the screws from the strap and door lever/lock assembly. Disconnect the linkages from the lock, and lever by flipping up the plastic retainers. Use panel removal tool, or wide thin tool to pry the panel from the door. How do you take off the lever that rolls the door windows up and down
unscrew the armrest, interior door handle, and the switches. Then start at either lower corner of the panel and pull gently. The panel is held on with small clips. Mine just poped out. Some will pull out of the door and others will pull out of the panel.
They can be removed and replaced from inside, you need to remove the inside door panel to get access, then its a few clips on the sides.
28
To install an exterior door handle on a Cherokee Jeep, first remove the window crank handle and the three screws in the inner door trim panel. Second, remove the inner door panel from the door using a trim stick and take off the vapor barrier inside the door. Third, remove the nut on the rear of the door handle, position the exterior door handle, and secure in place.
remove the interior door panel and you can get at the door handle, disconnect the rod and loosen the clips that hold it against the door, the whole assembly will come right out.
Yes.
First remove the door panel.Once the door panel is removed you will see three bolts that hold the mirror in place. While holding the mirror remove the three bolts and the mirror will come off of the door.