Just take a hammer and bang on it while spinning the rotor. Keep going until if gives.
Get a big hammer and beat it off. Spray penetrating fluid where you think it may get into the rotor to hub surface.
beat it off with a rubber mallet or get hub puller at part store
In order to remove any rotors that stuck on a vehicle, usually you have to hit the rotor hub part with a large hammer being careful not to hit the wheel studs. This is done to break the seal of rust that builds up which keeps the rotor stuck. On some occasions, the rotor will have little threaded holes in which you have to drive the correct size bolt through until the rotor pops off.
The Rotor has a small bolt that holds the Rotor on the shaft. Did you Loosen this bolt?
Remove the caliper, remove the caliper bracket, and remove speed clips that hold rotor. If the rotor is stuck , take a hammer and hit it squarely between the wheel studs.
You have to heat up the contact points the rotor around the studs with MAP gas then try hit it but if that doesent work then you need a torch (MAP and oxgen) to get it red hot.
Remove set screw. Then tap the rotor with a hammer. The rotor should break free. It has just rusted itself to the axle, due to condensation.
It is quite common for rotors to be stuck in place. Tap on the back of the rotor with a hammer, until the rotor is loose.
i have no clue i have the same problem with my Mazda 1999 626
Take off the calipers. If there are screws holding the rotor, remove them. If the screws are stuck, be careful when you use the screwdriver. You might round out the screw. If stuck, use a 1/4" socket wrench, 1/4" socket and a screwdriver bit. The screwdriver bit will fit inside the 1/4" socket. This will give you extra torque when removing the screw. The rotor should come right off.
remove wheel use i believe a T-55 torx bit to remove caliper if rotors are stuck carefully heat rotor center around hub assembly and remove rotor (easier said than done!!!) compress caliper piston with c- clamp replace brake pads and calipers then wheel. sometimes it is handy to remove the cap from the master cylinder to relieve air.
You call a tow truck and they will lift the front wheels