you need a 3 point puller ..can buy it just about anywhere and will make your life a lot easier then trying to pry it off
remove rear brake drums
A pair of channel locks works great to take the hub off.
= What tool to remove a front brake pads on a 2007? =
After jacking the car up and removing the front tires, remove the wheel-bearing dust cap, remove cotter pin, then remove nut, turning it counter-clockwise, then remove the large washer. Now, tap the top of the brake drum with the palm of your hand, and the front bearing should pop out. Then slide the brake drum off. If the brake drum does not come off, you will have to turn the brake shoe adjuster inward. The brake shoe adjuster is located in the slot in the back near the bottom ball joint. Pull brake drum off.
The front have pads, and the back have drums. If you are needing to replace them, they cost around 60. What is it you needed to know?
Pads on front. Drums on the rear.
you don't specify what kind of ford. if it's a pick up back drums are one piece with the wheel bearing hubs so you need to remove the axle and the front bearing . If it's a car, the drums are usually hold in place by 2 screw in the front near the wheel studs. hope this help
A car what has front disc and rear drum brakes have front brake pads and rear brake shoes.
is it disk up front drums in back
Yes , on the back wheels ( disc brakes on the front )
You can remove the front brake drum, on your Kawasaki Mule 2500, by removing the wheel and axle. The brake drum will slide off.
first you need to check your brakes 2000 vehicles dont have front drums, they have disk brakes