remove right side under dash panel remove blower cover unplug motor remove motor and blower regulator swap regulator on to new motor note all u need is a philpps head and a 15 and 25 torques
Don't know about a 2000, but a 93 S body (140) it is under hood on passenger side mounted on top of blower. Remove the cabin air filter and you will see it.
under the glove box there is a panel that holds the blower motor...remove the screws...4 i believe....remove the black plastic cover....there are three screws that holds the blower motor in...remove these and then remove the blower motor...unplug the power source and feed wires out of the hole.....reverse to replace the motor
Remove the covering under the glove box. Disconnect the power to the blower. The blower motor is fastened to the ductwork with 3 screws.
* Disconnect the negative battery cable * Remove the glove compartment and lower dash trim to gain access to the heater case and blower motor * Detach the blower motor cover and disconnect the electrical connector from the blower motor * Remove the blower motor mounting screws and pull the blower motor carefully out of the housing * If you are replacing the motor detach the fan and transfer it to the new motor
Disconnect the battery and let the vehicle sit for 20 minutes... Remove the right side panel insulator (passengers side)... Remove the (BCM) body control module and set aside carefully.. Disconnect the power plug to the blower motor.. Remove the screws holding the blower motor.. Remove the blower motor......
Behind the glove box on the passenger side. It's only 4 screws to remove the glove box and then 3 to remove the blower motor
Under passanger dash panal.There is plastic fasiner holding a kick panal up the blower motor is above it.
You will find the blower motor under the hood, on the firewall, passenger side, close to fender. To remove the blower motor, unplug the electrical connection at the blower motor, disconnect rubber cooling tube, remove the 5 small screws holding it in place, then wiggle the blower motor out and reverse procedure to install.U alsohave to remove the black box on top of the washer bottle.
How to change blower motor on 2000 grand am gt
how to change the blower motor
Open the glove box door. Now squeeze the glove box door sides and remove the door. You will see the blower motor. Remove the screws and presto the motor is easily removed.Enjoy JCHow do you access the blower fan resistor?
To change the heater blower motor on a 2000 Chevrolet Astro Van open your hood. After you open the hood you will see the heater box on he passenger side remove the four bolts holding the motor in and pull it out.