There should be a few screws holding the door in place usually around and next to the door handle on the inside of vehicle and a couple at the bottom left side of door, and then the remaining item holding on are blind clips be sure not to break them. Then lift the panel upwards and swing it out towards inside of vehicle ensure to remove and wire harnesses.
If it's the same as the 1996 Ford Ranger , open the drivers door and on the drivers end of the dash you will see a removable plastic fuse panel cover . The fuse panel is behind the cover
On a 1996 Ford Ranger ( fuse # 1 is a 7.5 amp mini fuse for the power mirror ) The fuse panel is in the drivers end of the dash , the fuse panel cover is visible with the drivers door open
Open the drivers door , and IN the drivers end of the dash you will see a removable plastic fuse panel cover ( the fuses are behind the cover ) on your 1996 Ford Ranger
Chain Saw
In a 1996 Ford Ranger : In the fuse panel in the drivers end of the dash ( the fuse panel cover is visible with the drivers door open ) ( #4 ) is a 10 amp fuse for the left headlamp ( # 8 ) is a 10 amp fuse for the right headlamp and fog lamp system ( # 33 ) is a 15 amp fuse for the high beam lamps
It's the interior trim panel in the drivers footwell just in front of the drivers door
That would be the plastic interior trim panel , by the drivers left foot , just in front of the drivers door
remove trim around radio, remove radio, remove the airvent extension, computer is mounted on the side of the instrument panel. 1 bolt, and 4 connectors
Remove the inside door panel from your 1996 Dodge Avenger. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install your new door handle.
how to remove the vent from dashboard of 1996 ford contour
A 1996 Ford Ranger could be equipped with a passenger side airbag ( SRS ) * so maybe yes and maybe no * All the 1996 Ford Ranger models have a drivers side airbag
rear drivers-side kick panel . . .