You put the screw back in the plastic, screw it in for a few turns & then pull the rest of the molly bolt out of the wall. It will leave a big hole that you need to patch & repaint.
Remove the big round plastic plug and use a 15mm socket to remove the bolt....That's it
Bad news. I have found it impossible to remove the bolt caps without breaking them. They are mortared on. They do make plastic bolt caps in a lot of different colors.
Move the steering shaft. There is one bolt under the plastic cover. This is the pinch bolt .Remove it and slide shaft towards firewall ,move shaft out of the way ,replace plug,re-install shaft,bolt and plastic cover.
There will be a cover on the end where the arm connects to the motor. If you remove that small plastic cover there is a 13mm nut threaded onto a bolt. If you remove that bolt and other hardware that follows you can easily remove the wiper arm.
First, REMOVE SPARK PLUG WIRE FROM SPARK PLUG, as you will be working near mower blade.Three inches from blade shaft, remove plastic bolt/plug with bare 3/8" drive ratchet extention, put in center of bolt, counter-clockwise of course. Wrench on outside of plastic bolt will work also.
SLEDGE HAMMER. That's how I did it. Then I found the bolt. You must first remove the plastic insert. The pivot bolt is toward the rear of the beast.
On my 99 you remove the headlight assembly by removing the two plastic covered wing nuts, then remove the side marker/blinker assembly by removing the plastic covered wing bolt, then the light is accessible. It sounds harder than it is!
Price
To remove the subwoofer, you have to first remove the plastic panel on the passenger side next to the third row seat. It is much easier to remove if the seat has been taken out. You will notice that the sub is attached to a large black plastic speaker box. The speaker is held in place by a large bolt on the back side of the speaker box that attaches the box to the magnet on the speaker. The only way to get it out is to remove the entire box from the panel to get to the bolt. Hope that helps!
There are no 'clips'. The filter is on the passenger side under the plastic cover just below the wiper. Remove plastic cover's weatherstrip; Remove plastic cover's center retaining bolt; Remove plastic cover's plastic passenger side 'screw'; Lift out passenger side cover; Filter is in the well. Pull it out. Installation is reverse of removal.
The door panel just snaps on. Get a screwdriver between the metal of the door and the plastic and pry plastic panel away from the metal. Also, there are 2 bolts that hold in the middle, one bolt is behind the door handle. You need to pull out the plastic cover behind the handle to get at that bolt.
It is a post-installed anchor used in the construction industry. Similar to a molly-bolt. http://www.westmidlandsfasteners.com/products.html