buy the clymer manual first. there are clips on the inside of the cups remove them press the Ujoint out of the yoke. someone told me you need to install the rear drive shafts with the yokes/u joints the same on both sides lined up. Mine were from the factory. thanks
jerk it real hard several times it will come out it is held in by snap ring
unscrew big nut on left side remove retaining ring from axle slide out axle be shure to remove wheel hubs first
how do you remove a outer rear CV joint on a polaris 400 sportsman 2004
The chain on a 2000 Polaris Trail Boss 325 is removed by loosening the retaining bolts and applying tension away from the sprockets. The chain can them be slipped off the sprockets and removed.
My 98 polaris trail boss does about 55-60mph
You have to pull the front clutch off to get to the rest of the bolts...
No, it isn't. The Polaris Trail Boss 350 is a liquid cooled 2-stroke.
I have a 1993 Polaris 250 Trail Boss. It won't start. It floods out the carb. Could it be low compression?
1990 vin location for a trail boss 4wd
I can get to 70-80 MPH
take out links
The location of the fuel filter on a Polaris 330 Trail Boss is in the fuel line that connects to the fuel pump. The fuel pump is located on the driver's side of the motor.
No, you don't mix oil into the gas of a Polaris Trail Boss 350 4-stroke. It is a 4-stroke engine, and you do notmix oil with the gas.
I need this information for regestering my ATV
1.9 quarts