What would you like to do?

How do you remove the rear quarter panel in Acura RSX 2006?

already exists.

Would you like to merge this question into it?

already exists as an alternate of this question.

Would you like to make it the primary and merge this question into it?

exists and is an alternate of .

By cutting it out. The rear quarter panel of any car is not like the front fender or something else bolted to the car. The rear is part of the frame so if it is damaged it must either be cut out and replaced or popped out by a professional who will actually drill small holes into it and pull it out from the inside not pull it out with one of those pops-a-dent pieces of junk.
8 people found this useful
Thanks for the feedback!

How do you remove the tail lights on a 2003 Acura RSX?

\n. \n Removing Acura Tail Lights \n. \nThere are are few bolts on the back of the tail light that can be accessed from inside the trunk. Then there are two screws on t

How do reset a maintenance light 2006 Acura RSX?

You have to hold down the odometer stick for like 10 seconds before starting your car continue to push it in while you start it and hold it for another 10 seconds.. It should

How do you remove and install a rear quarter panel?

I dont think you can...it looks one piece welded construction You have to remove taillight panels and scrape off sealant, then drill out all the spot-welds. It's do-able, but

Will an 02 Acura RSX rear bumper cover fit on an 06 Acura RSX?

No. 2004 and lower has a different tail light design. Therefore the bumper cover has the same design. The 2002-2004 have the little loops on the bottom of the tail lights. So

How do you remove an Acura RSX door panel?

First, there are 3 or 4 screws holding it, as I remember, and all of them located in the traditional locations. 2 of them on the inner door handle, the one U grab on to, and 1