Open the trunk. Pull out the 4 clips that holds the middle trim piece that's between the taillights. Then you can pull out the clips that holds the carpet from behind the drivers side taillight. After you do that then you'll see 3 10mm nuts, remove them being careful that you don't drop them. Its not fun finding them. After the nuts are removed the taillight pops out and you can remove the bulb. It should be a 7440 bulb. After you're done put everything back in the reverse order.
To add brake fluid in a 1990 Mazda Protege, you need to locate the brake fluid reservoir and check the levels. The reservoir is located on the master cylinder for the brakes.
Above the brake pedal,its black plastic.
HOW DO I TIGHTEN EMERGENCY BRAKE CABLE ON A 2002 MAZDA PROTEGE 5?
about 5mm then after that they will get hot and squeak
Next to the master brake cly.
My local VIP shop in Yarmouth, Maine, wants $540! Claims they need to shape the line and it takes seven hours.... I have a 1999 Protege.
this is a guess but most Proteges use DOT3
behind the engine on the firewall
Switch is defective or out of adjustment.
You have to go inside the trunk and remove the circular plastic covers from behind the lights. Then you have to unscrew the entire light and you can access the bulbs to replace them.
there is a brake switch under the brake pedal. This is a button that pretty much controls the break lights. you might need to replace this or look through the fuse box under the hood. (blue 15) is the fuse that powers the brake lights.
DOT-4 is recommended