answersLogoWhite

0


Best Answer

Open the back door, take the 2 screws out and just pull the lense strait back. Thers like little pegs that snap it into place. It'll seem like it will break, but it won't. Just pull it strait back and it'll just pop out!

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace a brake light on a 2005 Jeep Liberty?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you replace the third brake light on a 2005 Buick lacrosse?

How do you replace the third rear brake light in a 2005 buick allure


How much does it cost to replace a brake light on my 2005 Chevy Tahoe?

about 3 dollars


What is the part called on a Jeep Liberty 2005 that holds the passenger brake and tail lights?

Tail light lens, or assemble.


How do you replace a brake light switch in a 2005 Honda oddysey?

y want to replase the bolb from tail light for Honda odysey 1999


What type of brake fluid for 2005 jeep liberty?

Dot 3


How do you replace the third brake light on a 2005 Mustang convertible?

Crawl in the backseat, remove the screws on each side of the housing, pull off the light replace the bulb and re-install! Good Luck!


How do you replace brake light on 2005 KIA RIO cinco?

The brake lights on a 2005 Kia Rio Cinco are replaced by removing the retaining bolts, twisting the bulb, and pulling it from the assembly. A new bulb can then be put into place and the assembly remounted.


What bulb do you need to replace the lower tail brake lights in 2005 Mercedes Benz C230 Kompressor?

Bulb #7506 should be the correct brake light. See related links below.


How do you replace ac hose assembly?

how to replace ac hose assembly on 2005 jeep liberty


Why do your light stay on on your 2005 Subaru Outback?

Brake lights? Check brake light switch for adjustment or replacement


How do you replace the brake light bulb on a 2005 Chrysler Pacifica?

to chang ethe brake bulb, first lift up the rear hatch of the car, look to see what brake light is out, the you nee to look on the inside of the tail light assembly and you will see 2 scews or bolts holding the assembly in place take out those bolts and pull out on the brake light. next you will then turn the middle connector half a turn till it unseats itself from the assembly then you can replace the bulb


How to change a brake light on a ford ltd expedition 500 hundred series 2005?

In order to fix the brake light you would have to remove the cover panel from inside the vehicle trunk and replace the bulb. If you take the car to an Auto Zone store, they will do it for you.