answersLogoWhite

0


Best Answer

You remove four screws with a small L key and then carefully remove the top plastic from the speaker ......then remove the speaker from the lower plastic.....Its a bit tuff but it can be done and then replace speaker.....you also need to remove the receiving part from old speaker and use it to connect you new one. or you can cut off the plug and connect speaker direct and tape it

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace speakers on 2002 Chevy suburban side door?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are the speaker sizes for 2002 Chevy Suburban?

The 2002 Chevy Suburban features speakers which are 6 and a half inches. This size applies to both front and rear speakers.


What size speakers fit in a 2002 Chevy Suburban?

The front speakers in a 2002 Chevrolet Suburban measure 6 1/2 inches and are located in the doors. The rear speakers also measure 6 1/2 inches.


What is the recommended coolant for 2002 Chevy Suburban?

What type of coolant is recommended for a 2002 chevy suburban


The blower fan on 2002 Chevy suburban is weak can it be fixed or replace?

it can be replaced but check the resistors first they are probably the cause


What is the gap an 2002 Chevy Suburban?

0.060 inch


What is the wheel bolt pattern for a 2002 Chevy Suburban?

6x139.7


Where is the PCV valve on a 2002 Chevy Suburban 6.0 liter engine?

The PCV valve on a 2002 Chevy Suburban 6.0 liter engine is located in the engine. You cannot miss the valve.


How do you install rear speakers in a 2002 Chevy Prizm?

Attach the wiring harness to the back of your 2002 Chevy new rear speakers. Secure the rear speakers with the retaining screws. Put the rear speaker covers on.


Is their a fuel pump fuse on 2002 Chevy Suburban 1500?

Yes there is.


What size is the stock sub woofer in a 2002 Chevy Suburban?

it is 8"


What size is the gas tank on a 2002 Chevy Suburban?

37.5 gallons


What does it cost to replace abs module for a 2002 Chevy suburban at the Chevy dealer?

The part is approximately $920 from the dealer - that is just the ABS module and not the pump too. Installation will vary depending on your shop rates.